1995 Mercury Villager shots down when i step on the break.

The driver door module check the plug and check for corrosion in it and the plug the module is on the driver door under the door panel also do you have keyless entry that keypad could be shot a lot of people punch there #S in using there key which puts a hole in it letting water and outside air come in which messes it up so you know not me

Check and see if the fluid is low. If not it is probably the valve body or the planetaries in the ******. Good luck

there is a groups.yahoo.com/villager-quest owner group for help

the switch may not be completely broken,the contacts in the switch make contact sometimes & sometimes the don't,this could be the problem......hope this helps......cheers

no switch in van. Spray with penetratingoil & see if it loosens up.

Fixed back glass or does glass open? Handle on back glass?

Go here

http://groups.yahoo.com/group/villagerquest/

thermostat is on passenger side. Be very careful with reinstalling it or you will break mounting flange. Also, you will likely trap air in the system when you are done. Either burp it following directions on our site, or have a shop with evac/fill equipment drain and fill it for you. This will remove trapped air. $60.

go here and read files:

http://groups.yahoo.com/group/villagerquest/

sounds like you bought a bad tranny,was it a used 1 you bought?

You may need a new compressor.

The diagnostic connector is located on the engine near the starter. However, there are four connectors in that location and without pictures it would be difficult to determine which is the proper one

call a Mercury dealer and give him your 17 digit VIN number and ask him to check for any recalls. If yes, they are free,
Also, this site has files on most Villager & Quest problems.

http://autos.groups.yahoo.com/group/villagerquest/