My interior accessory lights don't come on?

Q: 2007 Nissan Frontier won't go into any gear - YourMechanic

https://www.yourmechanic.com > question > 2007-nissa...
Jan 31, 2017 · 1 answer
The shifter cable connects the interior gear selector to the transmission. This allows the driver to select the correct gear.

Nissan Frontier Stuck in Park: Diagnosis ' Drivetrain Resource

https://www.700r4transmissionhq.com > nissan-frontier...
Sept 10, 2019 - Nothing is worse than sitting in a vehicle that's stuck in park. The engine is running fine, but the shifter just won't move.

could be the starter motor is faulty

key wont come out or turn to off until gear selector is in park [ recognize that its in park ] your selector or transmission selector cable is damaged

The bezel around the shifter pops up. Tabs on each side(left and right). pry up with a screw driver. I believe it is a 194 bulb.

One of two things will make a vehicle's gear selector stick in park:

1. Brake pedal interlock circuit problem or brake pedal interlock solenoid failure; or
2. Problem with the transmission linkage.

FIRST THING TO CHECK: ARE YOUR BRAKE LIGHTS COMING ON WHEN YOU PRESS THE BRAKE PEDAL? If not, your brake light circuit is having an issue, which means that the gear selector interlock solenoid will not release the gear selector. Check the fuse, the brake light switch under the dashboard, and all connectors. If your brake lights are coming on skip that.
SECOND THING TO CHECK: Have you tried manually releasing the interlock override at the gear selector? Check your user manual. It will instruct you to place your key in the slot near the PRNDL indicator on your center console (assuming that your gear selector is not on the steering column), or where to release the selector manually if the selector is on the steering column.
ARE YOU PARKED ON A HILL? Sometimes, parking on a steep incline will cause the park pin to jam into place. If this occurs, you will need to push the vehicle uphill slightly (get a couple of friends to help) so that you may get the vehicle out of Park.
IF you cannot manually release the gear selector using the override, you will need to have your car towed to a garage and have them check the transmission linkage. Sometimes the linkage gets jammed, sometimes the park pin gets jammed, and sometimes magical trolls interfere with our lives covertly... best of luck to you!

Hi, check that the cable is attached to the gear selector on the trans and does the shift quadrant move as it usually did.... not sticking or stiff in it's movement. Auto's are basically a hydraulic pump forcing oil in through valves and galleries in the valve body,,,, it could be that a gallery is blocked or that a valve has jammed shut..... check all electrical connectors for a proper fit..... do all the lights on the shift indicator light up as normal, no engine check light coming on ?

Could be the brake switch or the solenoid that locks the shifter in park.
That circuit would need to be tested.

Your shifter cable sounds like it separated from the transmission or shifter or just broke. you are probably stuck in a moving gear so the neutral safety switch is disabling the ignition.

don't know if you've checked, but the shifter won't release if the brake lights are not working, it's the result of a bad micro switch...

there is a switch that the brake pedal hits when you push it, it releases the selector so you can pull it out of gear, that switch is bad, just look under the dash, push on the brake with your hand and you will see the button im talking about, replace it and its 100% fixed.