Windshield wipers not working, can't find fuse?

Do you know what a wiring diagram is ? A wiring diagram for your vehicles windshield wipers electrical circuit would show all components involved . You would need a wiring diagram for testing ,so you know which wires too test . It would show the fuse location - amperage etc.... Which of these is your vehicle - Notchback or hatchback or station wagon .

xTooltipElement
Service Information
2008 Holden Viva ' Optra, Viva (VIN J) Service Manual ' Body Systems ' Wipers and Washers ' Schematic and Routing Diagrams ' Document ID: 1964803
--------------------------------------------------------------------------------
Wiper/Washer Schematics
Figure 1: Wiper System - Notchback
Figure 2: Wiper System hatchback and Station Wagon
Figure 3: Wiper System Hatchback and Station Wagon w/Intermittent
Figure 4: Wiper System Notchback w/Rain Sensor
Figure 5: Wiper System Hatchback and Station Wagon w/Rain Sensor
Figure 6: Wiper System Hatchback and Station Wagon w/Intermittent and Rain Sensor
© 2019 General Motors Corporation. All rights reserved.

The fuse would be marked WPR fuse # 9 25 amp. located in the IP fuse panel . IP - instrument panel fuse box . It's location is
Fuse Block - I/P
Behind the left side of the I/P access panel
Windshield Wiper System
The windshield wiper system consists of a wiper motor, a linkage, a wiper arm and a blade, and a wiper/washer switch. The windshield wiper circuit incorporates a self parking device which consists of a worm gear and a cam plate in order to keep the circuit engaged temporarily when the switch is turned off. The wiper system is driven by a permanent magnet-type motor. The windshield wiper motor is mounted on the dash panel and is directly connected to the windshield wiper linkage.
The windshield wiper motor has 2 speeds, LO and HI, and also has intermittent wiper capability. The wiper switch is an integral part of the wiper/washer switch. Windshield wiper operation is actuated through the lever on the right side of the steering column.

https://www.youtube.com/watch?v=MvXX3Xg3siM

There are two relay's in the under hood fuse / relay box . Wiper relay an wiper relay 2 . Maybe one is bad . also check fuse #14 25 amp. Wiper fuse.Plus the BCM - body control module has a hand in making the wipers work . Are you familiar with automotive electronic control modules ?
The Wiper/Washer System consists of the following components:
• Windshield wiper/washer switch
• Body control module (BCM)
• Wiper micro relay
• Wiper 2 relay
• Wiper diode
• Windshield wiper motor
• Windshield washer pump
• Windshield washer nozzles
• Windshield washer solvent container
• Windshield wiper arm and blade assemblies
• Windshield wiper transmission
• WIP/WASH 10A fuse
• WIPER 25A fuse

Wiper/Washer System Description
The body control module (BCM) controls wiper motor low speed operation. The washer pump and high speed operation are controlled directly by the wiper/washer switch. The windshield wiper/washer switch supplies voltage on the signal circuits to the BCM for windshield wiper/washer operation. When WASH, MIST, DELAY, LOW, or HIGH is detected, the BCM energizes the wiper micro relay by suppling voltage to the relay coil. This allows battery voltage from the WIPER fuse to flow through the relay switched input then through the contacts and out the relay switched output to the wiper 2 relay switch contacts. Since the wiper 2 relay switch contacts are normally closed to the low speed circuit of the windshield wiper motor, the motor will operate at low speed.

Do you have any speed !

The fuse for the wipers is under the hood. And it is a green 10 amp fuse for it.

check book or call dealer.

Hi,
The 'stalk' that controls all these functions is faulty. Your truck SHOULD still be under warranty...Take it in.

GL,
Td

That involves airbag removal & a lot of delicate work. Let someone experienced handle it.

my 07 is fuse under dash number 41 look in your manual it will show you where it is located

wipers and washer should be on the same fuse
could be the switch

Check the relay relay maybe latched on. See if there is an identical relay in the box and swap them if problem goes away replace relay.

The fuse is the 20 amp WIPER fuse, located in the fusebox under the driver side of the dash, farthest on the left, 2nd one up from the bottom.