Need to reprogram open close on key
SOURCE: keyless entry remote
there should be a black box under the dash assosiated to the keyless entry you need to open it and there should be two pins next to each other you need to arc them together with a screwdriver you should see the blinkers flash then without releasing the screw driver press the button on the remote pad repeat this for the other remote
SOURCE: keyless remote does not work after replacing batteries
I had the same problem and located the addendum to the owners manual. It's kind of overcomplicated it seems. Here is what it says:
1) Confirm all doors are closed and the key is out of the ignition.
2) Open the driver's door and put the key in the ignition within 10 seconds.
3) Remove the key within 10 seconds.
4) Push and release the driver's door switch 3 times within 20 seconds.
5) Insert the ingition key within 10 seconds.
6) remove the ignition key within 10 seconds
7) press and hold both "lock" and "unlock" on the transmitter for more than 5 seconds within 20 seconds of removing the key All doors will lock/unlock to confirm the process has been properly done.
8) Press "lock" or "unlock" on the transmitter within 5 seconds of completing step 7. All the doors will lock/unlock to confirm that the process was properly done.
At this point the transmitter has been properly programmed.
Of course, this didn't help me. My transmitter still does not work. I did confirm the procedure with a known good transmitter, so it is valid. If the lock/unlock does not happen in step 7, you more than likely have a bad transmitter.
SOURCE: reprogram keyless entry system
1991-94 Nissan Maxima key less entry reprogramming procedure:
1. Enter the *original code found under the dashboard.
(*the code begins with the letter F and has 7 digits)
2. Close the doors and lock all of the doors,
enter the 7 digit code
( make sure you have your key in hand).
3. Once the code is entered correctly you will hear a long beep ♪ ♫.
While the beep ♪ ♫ is sounding ... ENTER your NEW 4 digit code, (you will then hear random beeps ♪ ♫)
Do not touch anything until the beeping ♪ ♫ stops.
4. To open the doors, the front windows and the
trunk,
type: S(Clear) and the New 4 digit code and the door will
open automatically.
5. IF by any chance you forget your new code. Just enter the original one and start all over.
SOURCE: can't find button under dash to reset/reprogram keyless entry
check this out - its not like the previous link - the button actually floats around with the wiring.
http://www.rs25.com/forums/showthread.php?s=8876327367f08262d9b387a75d9b5919&t=41265&page=2
SOURCE: Reprogram a keyless entry remote
Hello
this is how to program the remotes/keyless entry
How
NOTE
The 5 digit permanent code is located in one of the following places
I hope this help
Regards Paul
www.limotec.co.uk
1,023 views
Usually answered in minutes!
×