SOURCE: crown victoria window motor replacement
remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the top half. one is right by the handle, which is the one i forgot the first time i took my door pannel off. carefully pull the panel upward, and outward at the same time. Once the panel is off, disconnect the controls, and remove the light from the panel. Remove the plastic cover very carefully, it will tear, just keeps noise, and air, and the elements out.
There will be 3 screws, they are torx bolts, once you pull those 3 out. They are located middle of the door towards the right side. The motor will drop down a little bit. disconnect the wires for the motor, and wiggle the motor off of the regulator. the crown vics have a decent size hole to get into the door panel, you can also remove the speaker if that would help you do it. other than that, it just lining up the new motor into the car, pushing it into the regulator, and putting the 3 bolts in, make sure they are snug, and not cross threaded. put everything back together, and your set.
SOURCE: need wiring diagram for 2008 ford crown victoria
Hello,
You can purchase the wiring diagram for $5.99 from the following site: http://www.wiring-diagram.com/. You can also purchase a wiring diagram book from the following link: http://cgi.ebay.com/ebaymotors/2008-FORD-CROWN-VICTORIA-MARQUIS-WIRING-DIAGRAM-MANUAL_W0QQitemZ120394723100QQcmdZViewItemQQimsxZ20090320?IMSfp=TL090320147007r15080.
Hope this helps,
Chris
SOURCE: how to remove rear axel from ford crown victoria
do u mean the axle has "play" when u grab the tire and wiggle it up and down?? if it has play, then it propbably needs an AXLE SEAL AND AXLE BEARING.you will have to carefully inspect the axle itself where the bearing rides for any gouging or damage. THIS JOB requires a decent amount of mechanical skill. 1ST you need to remove the rear end COVER and drain out the gear oil into a drain pan.2ND remove the brake caliper and rotor . 3RD spin the" ring and pinion " around until u see a 5/16 bolt that passes thru from the pass. side to the drivers side. u have to remove this bolt. u will need to "hold "the gears from turning in order to break loose this bolt. 4TH remove this bolt and slide out the large metal ""PIN" that 'divides" the rear end in half. NOW CAREFULLY WITHOUT TURNING THE REAR END SPIDER GEARS,PUSH IN THE AXLE TOWARDS THE INSIDE SO U CAN REMOVE THE "C-CLIP" AT INNER END OF AXLE. now u can slide out axle and youll be able to replace seal and if needed axle bearing. let me know if u need more info.
SOURCE: 05 crown victoria police package rear axle removal
there are two main designs. One uses a bearing and flange at the backing plate area, release that and you can pull the axle and bearing.
the Other design is call a c lock axle. Inside the carrier, there are 4 spider gears. Two are splined to the alxes and two idle on an idler shaft. Remove this shaft, and then you can push the axle shaft inwards about an inch or so.
this will allow you to remove the c shaped retainer that is engauged with a groove at the inboard end of the axle.
So, now the bad news: often the c lock axle uses the axle shaft itself and the inside bearing race...which means if the bearing has failed, you need to replace the axle also.... Inspect carefully. Metal temper is the issue and once that is comprimised, you need to replace.
Doc
SOURCE: fuse diagram for 2000 crown victoria
there are 5+ pages of fuses what specifically do you need
461 views
Usually answered in minutes!
×