The back seat of my Mariner has a middle seat belt thatvretracts into the seat. Ona recent occasion, I folded the seat down in the customary way, but it won't return upright because the seat belt seems to be stuck in the retractor. If it is just jammed, I would like to fix it myself rather than take a day to go to the dealership.
You never need a dealer except for warrantee
work
You do understand that any repair shop performs
the same services & better in most cases
You have to wrestle the buckle out where it should
be & then snap the belt to get the retractor ratchet
working
If the retractor fails, then you have to get a complete
new belt assy at dealers parts counter
SOURCE: how to replace the defrost motor in my 2008
Thanks for using FixYa.com!
DON'T REPLACE THE MOTOR!!
The Motor is fine, the Blower Motor RESISTOR, not the Motor itself, is defective and must be replaced.
When the Blower Motor Resistor fails the Blower Motor will only work on High.
Let me know if this helped, or if you have additional questions: feel Free to contact us at FixYa.com!
SOURCE: what tool do i need to replace front brake pads on 2008 mariner?
You Will Need A 13-14 mm Wrench for Caliper Bolts .A Large Flathead Screwdriver to Spred open Caliper/Shoes to Remove Caliper from Rotor,
After rhis you Can use a LARGE "C" Clamp to CLOSE Caliper Piston.
SOURCE: Side Marker Bulbs
you need to remove entire assembly to access bulbs.it is secured by small hex head screws & a ''sliding tab'',an L shaped piece you pry up w/a flat screwdriver.
SOURCE: 2006 mercury mariner. stupid tail light assembly.
they are hard to take off sometimes, you are doing it right just keep willing it it will come off, there is 2 gromits that hold it into place might have a little dirt into the plunger.
SOURCE: 2006 Mercury Mariner - sticky gas pedal
I have a 2005 Mariner with the same problem. Always when the weather drops
794 views
Usually answered in minutes!
×