I recently replaced both struts in the front and my drivers side is 1.7 off how would i fix that? i been giving solutions just dont know which one to pick because ive had this fix. got hit on the left driver side. would replacing the spindle work? or just paying 260 to fix the camber work?
It takes a camber gauge to set the camber.
$260 is high for just setting up the front end, unless it includes parts.
Online Pep Boys show $89.99 + parts.
I'd let a professional do it.
Wheel Alignment
SOURCE: replacing non-heated left side mirror (driver's side)
This site will tell you what you need to know. good luck with this.
http://autorepair.about.com/od/otherodddiyjobs/l/aa092504a.htm.
In addition to the advice at the above site, I found another trick to removing the trim around the inside door handle. The above article refers to putting a screwdriver UNDER the door handle and pushing down ... to release a "secret latch". That's the first step. The second step (which is not in the article) is to insert the scredriver ABOVE the door handle ... vertically above the spot shown in the article. Then gently press the screwdriver handle down. With the screwdriver acting as a lever, the tip of the screwdriver will push UP on the top part of the trim. That will lift the trim up off a small pin on the handle mechanism. With both the bottom and top of the trim piece now "unlatched", slide the trim toward the back of the car, while you open the inside door handle (as mentioned in the article). The trim will come right off. Be sure to slide the trim toward the back of the car, as you move the trim away from the door panel. (There is a "hooked" piece of plastic on the back of that trim that prevents you from just pulling it out perpendicular to the door panel.) 'Hope these fine points help.
SOURCE: front driver side turn signal light doesn't flash
replace flasher......usually located in fuse block area...listen in this area....select passenger side ...then select driver side...you can hear flasher clicking...you have seperate flashers for each...FLASHERS are small cubes plugged into fuse block....probable bad driverside flasher
SOURCE: replaced HID low beam and still dont work on 02 jaguar xtype
Hi, you will probably find it has it,s own fuse, suggest you check fuse box, it will be a 10amp fuse (red)
SOURCE: Drivers side mirror replacement 02 Rendezvous
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
SOURCE: Front driver side suspension knock over bumps
See if you can bounce car and replicate the noise. If you can, you should be able to find it, and put your hand on it. Stabilizer bushing are a place to look, both at the lower a arm and on the frame. If you narrow it down to the strut, it will need to be replaced. The front trans mount also goes bad, try putting it in drive with your foot on the brake and give it some gas and see if the engine moves an excessive amount.
85 views
Usually answered in minutes!
You say you 'had' it fixed ? If that repair was an insurance repair, they should have taken care of that in/after the repair.
×