Timing alimnt marks nissan.2ltr engine

SOURCE: TIMING MARKS FOR GALANT

Here you go...

Greg Bernett

• 2993 Answers
• Posted on Jul 26, 2009

SOURCE: 1999 kia sportage timing marks

Crankshaft match marks


Align marks on timing belt pulley and pump body.

Camshaft pulley alignment marks

1. Align marks on camshaft pulleys with alignment marks on seal plate.
2. Install timing belt. NOTE: No looseness should exist on the tension side and at the camshaft pulleys.
   
3. Loosen tensioner lock bolt.
4. Turn crankshaft 2 revolutions in direction of rotation and check that timing marks are still in alignment.
5. Tighten timing belt tension lock bolt to 27-38 ft lb (32-52 Nm).
6. Apply a force of 22 lbs to timing belt between camshaft sprockets.
7. Belt deflection should measure 0.30-0.33 in (7.5-8.5 mm)
8. NOTE: Replace tensioner spring if timing belt deflection is excessive.

1. Install lower timing belt cover.
2. Install upper timing belt cover.
3. Install power steering drive belt and adjust belt tension.
4. Install fan pulley.
5. Install generator drive belt and adjust belt tension.
6. Install A/C drive belt and adjust belt tension.
7. Install splash guard.
8. Install fan and fan shroud.
9. Install 4 fan bolts. Tighten to 24 ft lb (33 Nm).
10. Install fan shroud mounting bolts.
11. Install fresh air duct.
12. Connect hose to resonance chamber.
13. Connect battery negative cable.

SOURCE: car repair manual for a 1997 suzuki vitara v6 2ltr petrol 24v

Haynes don't cover that engine. I've found a copy of the H25 engine manual which is similar to the H20 engine we have. If you search for SQ416 in google you'll find a copy you can buy or if you're lucky you'll find a free download somewhere like I did!! :-) It has helped me loads.

steve morris

• 1675 Answers
• Posted on Feb 26, 2010

SOURCE: 2000 honda ..... timing belt replacement

hi i have a diagram of it here and as far as i can see the marks on the twin cams are actually aligned with the top of the cover edge there should be an arrow on each cam pulley, that is pointing upwards, and you should have 2 marks either side horizontal and line up with the cover , the bottom crank pulley has a v cut out which lines up with a mark which is a angled line on the engine cover my picture may be different from your one if you want you can email me i will send you it so you compare it to your one
[email protected]
hope this helps

SOURCE: timing marks and aligning timing belt

the marks for th cams are on the tin stuff behind the gears study it for a bit and nyoull see them the mark for the crank pully is on the case onthe bottom of the crank pully just of to one side