Remove the inner door skin.
Remove the window location bolts at the base of the window.
Remove the motor mechanism retaining bolts and its wiring loom.
Remove the motor and replace.
Reverse above instructions for reassembly.
SOURCE: 2003 nissan 350z will start but dies within
most likely a fuel pump issue. spray some break clean in the intake ande see if you can rev it up as your spraying, If you can you havea weak fuel pump
SOURCE: car will idle but there is no response when
This car uses "drive by wire" technology and uses a sensor to measure gas pedal movement. This sensor the transmits the info to the engine. So there is no mechanical throttle cable. You might have a bad accelator pedal sensor or it could have a loose wire. Take a look under the dash at the pedal and see if you can locate the sensor and verify it is still connected.
SOURCE: I need to replace the exterior driver's side door
yes you are right you have to remove the inner door panel give these websites a try www.autozone.com and www.alldatadiy.com if all fails stop by your local nissan dealership in the part department and they be able to print out pictures and diagram showing you how to replace your door handle wish you the best of luck Michigan Man.
235 views
Usually answered in minutes!
×