SOURCE: e-150 fuel pump inertia switch location
on some fords it is on pass side kick panel you have to feel in a hole and you will feel a reset button,hope this helps
SOURCE: location of inertia switch/fuel pump
Yes it can. It doesn't take much like slamming a door or dropping a load of parts. There is only a magnetic ball inside the contacts and it is a wonder that Railroad tracks and Potholes do not trigger more shutoffs. All you do is find the switch and hold down the button on it for about 3 seconds.
Then try starting the van without slamming the doors shut until it is running. If the Inertia switch does not help check the fuse panel, then the relay. The relay should either be in the Black powerbox group or in with the fuseholders.
SOURCE: does the fuel inertia switch
Since this trips to prevent fuel from pumping in a collision, it is made to be manually reset. The device on a son's Ford used to trip occasionally on our rough easement. On his car it was located behind a panel in the trunk.
SOURCE: 2001 ford mustang inertia switch
Hello camcashkye62,
It's LH rear of the luggage compartment, see picture below.
Regards,
netvan
The fuel pump shut-off
switch is located on the
left side of the trunk
between the left rear tail
light and the trunk liner,
and to the left of the
hole in the trunk liner
To reset the switch:
1. Turn the ignition OFF.
2. Check the fuel system for leaks.
3. If no leaks are apparent, reset the switch by
pushing in on the reset button.
4. Turn the ignition ON.
5. Wait a few seconds and return the key to OFF.
6. Make another check of leaks
2,237 views
Usually answered in minutes!
×