On my 1994 Chrysler concorde3.5 had both crank/camshaft sensors replaced. Car ran for a while but kept wanting to stall. eventually cruise control light came on. still ran for about 20miles until cut off completley while driving. replaced the ignition coil but it refused to start. Any suggestions.l

SOURCE: Crankshaft Position Sensor location 04 PT Cruiser

It is located behind the **** of the starter on the front of the engine starting in '03 the 2.4 lt was changes the repair manual failed to update this..you may sneak it out with small fingers with out pulling out the starter.

SOURCE: Car won't start/fire up

Check all the grounds sounds like what i had on my truck. It took a good mechanic to find it but it ran after.

SOURCE: Crank sensor and camshaft sensor

The crank sensor is in the top of bell housing of the transmission towards the back of the engine compartment. The cam sensor is built into the distributor.

SOURCE: 2003 chrysler 300m o2 sensor and camshaft position sensor

SOUNDS LIKE YOU HAVE CAMSHAFT DAMAGE.

SOURCE: Ignition coil keeps busting open

YOU EITHER HAVE A COIL DRIVER CIRCUIT WIRE SHORTED OR FAULTY ENGINE CONTROLLER(PCM)..CHECK NEAR TRANS DIPSTICK FOR ANY DAMAGED/MISROUTED WIRING..HAVE SEEN IGNITION COIL DRIVER CIRCUIT PROBLEMS WITH PCM'S IN THESE VEHICLES ALSO