2003 Hyundai Accent Logo

Related Topics:

Posted on Nov 14, 2012

Accent crdi car morning starting problam - 2003 Hyundai Accent

5 Related Answers

Anonymous

  • 776 Answers
  • Posted on Jun 02, 2009

SOURCE: i would like to bye

Read the Owner's Manual

Ad

Anonymous

  • 1 Answer
  • Posted on Jan 06, 2011

SOURCE: my accent crdi is not

Vehicle start but quit after 10 seconds. In this car we replaced ECM & engine Wiring also fuel pump but problem was not solved. Can anybody help us ?

My email Id - [email protected]

Anonymous

  • 1 Answer
  • Posted on Mar 21, 2011

SOURCE: Hi, Am planning to buy a

wheel archs rot from inside on mine and dont do high millage due to worn out ball joints ect theese cars are not bult to live forever

Autotroubles

Sam Akber

  • 1149 Answers
  • Posted on Sep 16, 2011

SOURCE: Hi, I've an accent crdi 2003. In mornings engine

I would check the catlic converter to see if its not blocked, best thing to do is to go to a exhaust shop and they can do vacume test or tempreature test.

alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on Feb 27, 2012

SOURCE: accent crdi back compretion started recently

try again my explorer locked up ,right front pulley behind it is the timing gear which is locked into place by a keyway ,this keyway wears and rattles plus the timing gear so the timing is out and the valves hit the pistons ,result back pressure from the bent valves ,the keyway and on the front of the timing gear is another roll pin into the crank nose and they all break here allowing the keyway to chomp away at the timing gear and woodruff key .Result an expensive repair on this diesel engine

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Hello all I have an accent 2005 CRDI. It starts in the morning After a little ride It stubborns to start and I can see lot of smoke and the mechanic says it is fuel injector problem. Please advice .

Venkata, According to Injectorrx.com: "
Fuel injector symptoms for bad, faulty, dirty, clogged, or leaking injectors are :






  • Starting issues


  • Poor idle


  • Failed emissions


  • Poor Performance


  • Engine does not reach full RPM


  • Increased fuel consumption


  • Rough engine performance


  • Surging and bucking under various throttle loads


  • Smoke from the tail pipe


  • Engine Knock or Detonation which can lead to catastrophic engine failure


  • Pollution"



Venakta: I have had very good luck with a fuel injector cleaner sold by Advanced Auto called KX44 but some people like Seafoam. It is a cheaper place to start than with a mechanic.
0helpful
1answer
0helpful
2answers

2003 Accent crdi is run 10 kms and then all of sudden it stops and than if u crank several times it dont start. Try after an hour it will start , and again repet the same problam

clogged catalytic converter, classic example of what happens when they go bad. You have all the signs and symptoms. 98% sure its stopped up.
0helpful
1answer

Hi guys , I've an accent crdi 2003,engine starts not normally, Engine is totly overhall, but not good starting

take it back to who eve t=did the overhaul or check spark plugs spark plug cables, disrtibutor box
0helpful
2answers

Hi, I own an accent CRDi '03. My problem is that, engine wont start in the mornings. But it does start on jump starting and push start. After that it runs normally and starts normally. I've checked...

Hi, I think you have a bad altinator or eletrical short which drains your battery over night, once you jump start your vehicle the altinator charges your battery enough that it starts all day but if it is parked for longer time the battery drains.
0helpful
4answers

Hi, I've an accent crdi 2003. In mornings engine

I would check the catlic converter to see if its not blocked, best thing to do is to go to a exhaust shop and they can do vacume test or tempreature test.
0helpful
2answers

2002 Hyundai Accent Problem

first thing i need to know is did the timing belt break?
second is are you sure you aligned the timing marks and after the belt tensioner was tight you rechecked to make sure the timing stayed where you had it.
next step would be a compression check to if a valve was bent whenchanging the belt
i have seen this happen and this engine is an interferance engine.
later paul
Not finding what you are looking for?

73 views

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...