I need to replace my glow plugs on my frod diesel F350 Super Duty
SOURCE: Shut 05 Ford f350 diesel off wont start
when you get a code the PCM will keep that code and till it get easased. you need a scaner or disconect your battery for 1h. this should clear your codes. when the battery is disconected don't sit in your can. the air bags may deploy if you hit the steering collem or a sensor to hard. just let it sit. reatach your battery then try to start your truck. if the codes are still pressent you make need let the car sit for longer or bit the big one and get the shop to do it.
SOURCE: Ford Diesel glow plug relay goes out every year since 1993
Wow that sounds expensive for a relay. You didnt say what year it is and you thought it was a 7.3 powerstroke. Sounds like its a 6.0 powerstroke I could see that relay costing that many bones. If its a 7.3 liter you should be able to buy one them glow plug relays yourself and with a basic set of sockets change it yourself. You just need to unhook both ground wires on the batterys before you start. Should take like 30 mins max on a 7.3 liter. But a year and engine size would make it easier to help you.
SOURCE: F350 Super Duty Diesel 2005
I had the same problem with my '05 F350, it's the Fuel Injection Control Module (FICM). My dealer replaced it under warranty, and even picked up the tow!!!!!!!!!
SOURCE: Shut 05 Ford f350 diesel off wont start
dies the truck restart once it cools off? it is very common for th 6.0 to have high pressure oil issues on a hot soak. they will run till the cows come home but once shut off they can not build up enough pressure by cranking speed alone to start truck until it cools down and the seals become rigid enough to bridge the gaps they are sealing in the first please. if this is the case. it may be the STC fitting ojn the back of the high pressure oil pump (intake and turbos must be removed to check) or possibly the branch tube o rings have worn. the branch tubes are located under the valve covers and supply the fuel injectors the oil they need to perform their "power stroke"...
SOURCE: 2000 ford super duty 7.3 diesel will not cold start
you need to have the engine coolant switch
checked,since the computer relies solely on sensors,the ect tells the computer how cold or hot it is so the
computer will make it a rich or lean mixture to start the engine,if it tells the
computer that it is 75 degrees the computer will lean the mixture like starting
a car in the winter without a choke.
1,276 views
Usually answered in minutes!
×