2004 mercury mountaineer as soon as key is turned to 3rd position(on/run) engine starter is activated and engine turns over, wouldn't be a problem but starter sometimes runs longer then necessary and grinds as if holding key in start position after engine is running. I believe it is related to a unknown device that recently came loose hanging near brake pedal I replaced zip tie that had snapped but there is a black wire that is snapped with no indication of where it goes, box is translucent black, looks like a vertically elongated D where wires enter flat part of D and green light constant at rounded part of D. Any help or suggestions appreciated will try to load pictures after work, THANK YOU
SOURCE: 2004 Mercury Mountaineer Problem...wont turn over
just be liitle more specificc please do you hear any noise when you try to start it? like a click or something?
SOURCE: 2001 Mercury Mountaineer won't start
Have a load test done on the battery. If it checks out good, take a voltmeter to the battery and have an assistant rotate the engine. If you see more than a 2 volt drop when the car is being started, the starter is heading south.
SOURCE: brake lights stay on when vehicle shut off
The BRAKE LIGHT SWITCH needs to be Readjusted, Simply Move it Closer to Pedal Arm to Adjust. There is a NUT that you must Turn to do this. If you take a Good Look at it it is SELF EXPLANITORY.
I Hope this Helps , Well I Know it Will as it5 is OBVIOUS as to what the Problem is. Have a Good Day
SOURCE: 1997 Mercury Mountaineer What is Catalyst Efficiency Below (Bank
it means the catalyst is worn out, the efficiency is monitored by sensors, when the Cat falls below a certain reading or "threshold" the code is generating telling u that u need a new catalytic converter.
153 views
Usually answered in minutes!
×