2003 Dodge ram 1500 4x4 need to know how to remove front axle from front differential to replace hub bearing assembly.
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
REMOVAL
Do you have to remove the whole hub if lower ball joint is attached to the steering nuckle and not the a shaft
10,486 views
Usually answered in minutes!
how do you removal the front wheel bearing hub for a 2003 dodge ram pick-up. I have removed the 3-bolts. Is there some kind of puller or you just pry and bang the thing out?
cant tap cv axle in dodge ram 1500
cant get front right side axle out of differential
want to remove headlight lens on 99 dodge ram 1500
how to reinstall front bumper all parts
that is it
×