Go back under the truck and check to make sure all the fusible links at the starters battery post are hooked up and have continuity through them. I thank you left one off.
SOURCE: starter runs constantly when u connect the battery
Check the wire from the battery at the starter there is a tab to keep it from spinning when you tighten the nut,it may be touching the other nut on the solenoid causing the starter to spin.You can also remove the wire on the solenoid that engages it then it should not spin.If it does it is a starter problem
SOURCE: How do I replace the starter
the starter will be at the rear of the engine. Disconnect all of the cables, remove the 3 or 4 bolts that hold it in. Pull it straight out of the engine. Install the new starter. Starters are fairly straightforward, but sometimes awkward to reach.
SOURCE: headlights and dash light dont work
You would have to check and see if you are getting any power out of the light switch. There is a seperate wire for the headlights and the dash lights.
SOURCE: 2001 pt cruiser limited won't crank
needs a battery but be careful cause sometimes a bad alternater will cause the battery to go bad
SOURCE: 98 jeep tj, dash light/taillights/licence plate light don't work
disconnect head lights, and replace fuse. Then turn the light back on to see if it blow a fuse again. if not, plug on light in at a time. You might have a bad headlight???? then unplug that one if nothing happens. Then plug the other one in. It could also be a bad taillight bulb. I have had bad tail light bulbs. Do all of them, one at a time.
99 views
Usually answered in minutes!
×