I can't open my hood and the latch doesn't work on my 2000 Chrysler Grand Voyager. I have a leak & I need to find out what is leaking

CHECK FOR VACUUM LEAKS AROUND INTAKE AND UPPER MANIFOLD

WHEEL WELL UNDER , BOTTLE HAS PUMP ON LOWER SIDE

Replace the speakers if they are amplified types.

3.3 AND3.8 ENGINES TAKE OFF SERPENTINE BELT 15MM ON BELT TENSIONER . REMOVE 2 HOSES OFF PUMP. 5 ?BOLTS AROUND WATER PUMP. IT WILL COME OFF WITH ANTIFREEZE LEAKING OUT. HAVE DRAIN PAN UNDER . ALSO IT IS GOOD TIME TO CHANGE THE LOWER HOSES. REINSTALL WITH NEW GASKET, FILL SYSTEM, PUT HEAT ON HOT AND RUN UNTIL THERMOSTATE OPENS, AND CHECK FOR LEAKS, TORQUE IF NESSESARY ( ENGINE OFF)!!REFILL AT SIDE TANK

its a stuck sensor or relay ,, fans will run with the car off until the desired heat and or cooling is completed . check the under hood fuse block for a relay for the fan, see if you have another one that's the same, and switch them out,, if it stops and works ok,, replace the bad relay

If antifreeze is leaking into the cylinders you are going to need the head gaskets replaced. and yes both of your issues can be fixed BUT it would probably cost more or as much as a new car (~$1500-$2000).

If you are talking about the steel line then it has to be replaced, you can get the lenght you need to change from the parts place. Get the line already flared and with quick connect couplers that way you will only have to flare the ends of the line on the vehicle.

probably the evaporator leaking the noise may be just the freon going through the system, you have to remove the entire dash to access the hvac box to remove it to replace the evap seek a professional

open hood, at right side of vehicle underneath wiper module, at firewall, no need to remove wiper module.let me know if this help

your are get air in line form some where start at top a work down.