Color code iat sensor 2012 ford F-250

I did a quick Google search for "iat wires for e350", looked at the image(s) results - lots of images with digragms, color codes etc.
Try it yourself RE: you may recognize your configuration.. and find the diagram for your vehicle.

you lost the colors.? or are there 2 wires there that you know are IAT but dont know which pin fit them.?
no matter, either pin works.
the sensor is not electronic, its just a resistor, that is non polarized
the ECU sends current to the IAT, the current that flows, tells the
ECU what the air temperature is. in the intake.
no car year stated
no engine option stated in F150
so NO ANSWER exact , ever. (country helps too, but ill not say that it scares folks to death for some reasons)
Im in USA and ford does EXPORT cars and trucks.
the IAT is a thermistor, the FSm shows how it works and how
to test one easy, super easy, ask.

tell more get more.

IAT, is the air temp.
this sensor varies by what engine you car has. (and country)

you could just log i to alldata.com and look, its all there.
3.5 L V6 this engine? is common in USA>
out side USA is this
It is equipped with a 2.4 L engine and CVT
vast diffr. engines... no body ever post engine or country so i must as
the questions.
why are you worried, about IAT, just a clue, helps.
the scan tool said its bad?
ok , i logged in for you, looked up this sensor
and this 3.5L has a MAF, Air flow meter near air cleaner.
and guess what , the IAT is inside the MAF !!
why not post the why so we can help,
post symptoms. or, scan codes, or? really

That sounds like a Mass Air Flow sensor. Why are you checking it? What are your symptoms? Make sure your air filter is clean.

The first and sixth wire are IAT.------

That is grey wire and grey with red wire.-------

The first one is only grey and second one is gery/red wire.

---------

This will help.Thanks.Helpmech.

Hello! The Intake Air Temperature (IAT) sensor has the following wire colors...Gray/Red and Gray...


Guru...Saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

As long as you are talking about the new body style ( 3V 5.4 L )

The module is the MAFS and the IAT sensors

The IAT section is :
PCM to IAT is Gray wire
The return to the electronic engine controls from the IAt is Gray w/ REd stripe wire

The MAFS
PCM to MAFS ( MAF ) is Light Blue w/ Red stripe wire
The MAF return on the PCM is Tan w/ Light Blue stripe wire
The ground ( same as the Charge motion control valve ) is Black w/ White stripe wire.

Violet/Grey

red with blue stripe and black... cut the red with blue strip and connect one end of the resistor to the harness side. Then splice the other end of the resistor to the black wire... do not cut it just splice into it.