P0136 ck engine light
P0136 is an oxygen sensor check code for sensor 2 in bank 1. This can indicate a faulty sensor, but more commonly it indicates an issue with the exhaust. There may be a leak somewhere near the sensor causing an erroneous report to the engine computer for fuel to air ratio in the exhaust. This can be difficult to detect. At a garage, they will probably use a smoke machine to detect airflow around exhaust gaskets to spot a leak, barring that, they will replace the sensor. If the light still comes on after confirmation there are no leaks and the sensor has been replaced, it would indicate a problem in the wiring on the line between the sensor and the engine computer.
Further reading about the code can be found here:
http://www.obd-codes.com/p0136
SOURCE: 2000 Windstar rebuilt engine won't crank theft light comes on
Refer to the owners manual for dis-arming procedure for the anti-theft, if you do not have the owners manual here is a link to Ford for a free PDF file of the owners manual.
http://www.motorcraftservice.com/pubs/content/~WOYWIN/~MUS~LEN/41/00winog1e.pdf
SOURCE: Ford Windstar oil leak
Most possible oil leaks from valve cover rubber oil seal. Remove valve cover, inspect , clean surfaces, and replace with new rubber oil seal .
Good luck!
Thanks for using fixya.
SOURCE: 2000 ford windstar van belt diagram!!
There should Be a Factory Sticker under the Hood that gives you the Exact Routing. Check in the Back of the Owners Manual. If not let me Know!
SOURCE: 2000 ford windstar anti theft light flashing vehicle won't start
This means that your key is not being recogonized.Ethier the chip in the key is bad or the patts transciever at the lock cylinder. Do you have a spare key? If not you will have to get 2 new keyss cut and programmed.
SOURCE: 2000 ford windstar airbag light flahes then stays on
You should take the vehicle to a certified dealer immediately; Your airbag could deploy prematurely causing serious injury or death!
1,075 views
Usually answered in minutes!
×