Changing rear spark plugs
SOURCE: changed spark plugs and wires now car wont start
I know this might be obvious but the obvious is often the problem. Did you replace the coil wire that goes from your coil to the distributor cap? Also, double check to be sure that your wires are connected in the correct order. A little more clarification might help. Does it turn over? Does it just click? When you turn the ignition key then let off does the car clunk or make a wheezing sound?
SOURCE: i have 1991 Oldsmobile cutlass Ciera had oil
Bad connection at spark plug and wires or coil pack. Possible a plug got cracked on the install. Possibly the wires were installed incorrectly.
SOURCE: Changing spark plugs on a 1995 Oldsmobile Cutlass Ciera
ALL YOU NEED IS 3/8 RATCHET WITH A 5/8 SPARK PLUG SOCKET.YOU NEED EXTENSIONS AND UNIVERSAL JOINTS TO GET TO HARD TO REACH PLACES.YOU NEED A SPARK PLUG GAUGE.YOUR SPARK PLUG GAP SETTING WILL BE. 0.060 THAT WILL BE FOR THE 2.2 AND 3.1 ENGINES.
Testimonial: "Thank you very much for your advice and time!"
SOURCE: po300 multiple misfires.I have changed the coil
reset the ec module by disconnecting the battery for a few minutes. If that does not work have autozone do a free scan and ask them to reset the codes.
SOURCE: How do I change the spark plugs and wires on my
First you have to locate it. The spark plugs are located on the side of the engine heads and can be accessed through the wheel well. The no. 3 spark plug will be the hardest for you to get to, you need a spark plug socket with a built in swivel to loosen it and then remove it and install the new one by hand and the socket can only be used to loosen and tighten it.Vote for me if it helps
Testimonial: "Helped alot! I was told I was going to have to Rock the whole motor forward just to get to it! Thank you!"
188 views
Usually answered in minutes!
×