When you starts the car three off the lights are on abs wrench andservice changed three sentors still dont go out just on times it will go out the miliage on the car flashes the lihgts comes on when it is reading firm the lights go out fist starting the car it will be out but in gear lights comes on wanting to know if this has a proplem with the computer or wiring
SOURCE: My 1999 Pontiac Grand Am GT keeps stalling out while driving
there are 2 possibilities off the bat i could think of. first suspect would be fuel pump. they can be very intermittent with gradual progression. next common problem for this symptom would be security issues. make sure youre using genuine GM key. ck body control module for codes. code b2960 in HISTORY would indicate faulty bcm. there are also issues with invalid "passlock" data whcih is a security sensor attached to ignition switch. tricky to replace and reprogram so be careful.
SOURCE: 99 pontiac transport- tcs,abs,emerg brake and low traction(flash)
Have the ABS system scanned for codes. The ABS and Traction control use the same computer. You likely have a bad wheel speed sensor.
SOURCE: THE CAR WON'T START. THE
Start with using a different key if available. Faults occasionally occur within the chip in the key
SOURCE: abs light and trac off light both came on dash at same time
These two are linked together the abs light is probably on for a bad component like a wheel speed sensor or something like that, this will automatically trigger the TRAC light to come on. To check it must be done by a code scanner/computer. This can be check at an auto zone for free. Then I will be able to help with the code. In most case the most common problem is one of the four wheel speed sensors for the abs system. Good luck and thanks for using FIX YA.
SOURCE: abs and traction control light faults after a brake job. 2005 Pontiac grand prix
You have a bad sensor at one of the tires that need replacing that operates ABS and traction control. If you take it in to a shop it will run $130 but they can find which sensor is causing the problem. But if you do it you might have to replace all 4 sensors to make sure you got the right one. Every hard to diagnoses. Its better for the shop cause they can get electrical read outs for each sensor.
http://schematicsdiagram.blogspot.com/2011/12/heating-knob-light-bulb-under-dash.html
----------
Parking lights, tail lights and dash lights
not working?
http://technoanswers.blogspot.com/2012/01/parking-lightstail-lights-and-dash.html
---------
How to replace Instrument panel and dashboard?
http://repairhelpcenter.blogspot.in/2012/02/how-to-replace-instrument-panel-and.html
-------
Tail lights and dash light fuse keeps blowing?
http://technoanswers.blogspot.in/2012/02/tail-lights-and-dash-light-fuse-keeps.html
---------
This will help.
Thanks.
42 views
Usually answered in minutes!
×