SOURCE: need the crankshaft main bearing torque specs and
Hello tlittle3: My name is Roger and I will help you.See the attached image. Be sure to follow steps as it is very inportant. You will notice that you need to index some of the bolts. That is merely turning the bolt a specified degree. The crankshaft tie bolts are the bolts that are in the side of the block. install horizontal. Shold you need further help please just ask. Please rate the answer you received. Thank You for using Fix Ya. Roger
Testimonial: "thanks that what i needed"
SOURCE: Crank shaft bolt torque specs for 2001 chrysler
the dampner is the crank bolt
Testimonial: "This expert is amazing, smart and extremly helpful."
SOURCE: WHAT ARE THE TORQUE SPECS FOR THE INTAKE MANIFOLD
Sorry first attempt got sent by accident
Upper intake manifold bolts/nuts 168 in-lbs
Lower intake manifold nuts are done in 4 steps
Step1. Front nuts 61 in-lbs
Step2. Rear nuts 185 in-lbs
Step3. Front nuts 185 in-lbs
Step4. Repeat Steps 2 and 3
SOURCE: I need the head torque
CYLINDER HEAD TORQUE/SEQUENCE:
Use the special tool and a torque wrench to tighten the bolts to 103 - 113 Nm (76 - 83 ft. lbs.) of torque in the order shown in the illustration. Tightening should be done in two or three steps.
CAUTION: Install the head bolt washers with shear droop upward as shown in the illustration
217 views
Usually answered in minutes!
×