What fuel should a 1990 mazda 626 run in australia
You can run 89 octane without any issues, no need to run the premium unless it states it in the manual or on the dash.
All the petrol stations only seem to have unleaded 91,95,98 etc is this a differnet type of fuel. Sorry Im new at this
use the 91 and you will be fine
Thanks you, sorry I seem a bit dumb but I dont have anyone to ask. It was my grandads car and he gave it to me just before he died so I want to look after it as well as he did.
×
SOURCE: charge light flashes and becomes solid when my mazda 626 idles
Hi,
Initially, there are only a limited number of reasons why the charge indicator would light up:
Since the battery is new, that would leave us with the first three (3) possibilities. Of the three, the first two could be inspected/checked even by the user. A suspected alternator would have to be bench tested to confirm if faulty. Often problem with these alternators are a defective built-in regulator. In most instances, it would be more practical to replace the alternator (if found defective) rather than to repair and just replace the regulator.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.
SOURCE: Mazda 626 turbo 1990 power steering cuts out
is your pump belt slipping? To change the oil you need to remove a hose, drain the fluid and replenish. However, I have a feeling that you need anew pump or your rack and pinion is binding. And these are items that need replacement.
SOURCE: how do i replace the fuel pump in my 1993 mazda 626 2.5
1. Relieve the fuel pressure and disconnect the negative battery cable.
2. If not already removed, depress the clips on each end of the rear seat cushion and remove the cushion.
3. If not already done, detach the electrical connector from the fuel pump/sending unit.
4. Remove the attaching screws from the fuel pump/sending unit access cover and remove the cover.
5. Disconnect the fuel supply and return hoses from the fuel pump/sending unit.
6. Remove the attaching screws and the fuel pump/sending unit from the fuel tank.
7. Detach the sending unit electrical connector, remove the sending unit attaching nuts and remove the sending unit from the fuel pump assembly.
To install:
1. Attach the sending unit to the fuel pump assembly and install the nuts. attach the sending unit electrical connector.
2. Install the fuel pump/sending unit into the fuel tank with a new gasket and install the mounting screws.
3. Connect the fuel supply and return lines.
4. Install the access cover and the mounting screws.
5. Attach the sending unit electrical connector.
6. Position the rear seat cushion over the floor, making sure to align the retaining pins with the clips. Push down firmly until the two retaining pins are locked into the rear seat retaining clips.
7. Connect the negative battery cable, start the engine and check for proper system operation and for fuel leaks.
SOURCE: How to Replace a Fuel pump on a 2000 Mazda 626
yes it isn't that much if you buy them.they slide inside the coupler and release the line.
Testimonial: "Thank you didn't know if there was a tool for this."
SOURCE: i have a mazda 626 with a idle problem
Go to carhelpsite.com it is free as long as you click on 2 of the ads at the website then your questions will be answered by an ASE certified mechanic,you don't have to buy or fill out anything on the ads,so help keep the site free.
184 views
Usually answered in minutes!
×