Oil was changed and they forgot to reset the button. How can I do this?
Instructions
SOURCE: Lexus RX350 Reset Maintenance required light
PRESS AND HOLD IN THE TRIPOMETER RESET BUTTON. WITH IT IN, TURN THE KEY TO THE ON POSITION WITHOUT STARTING THE ENGINE. THE DISPLAY WILL COUNT DOWN IN HASH MARKS FROM 6 TO 0. AFTER IT REACHES 0 RELEASE THE TRIPOMETER RESET, TURN THE KEY TO THE OFF POSITION. ONCE YOU RESTART THE LIGHT SHOULD BE OFF.
SOURCE: Reset oil gauge after oil change
ignition on, hit the gas pedal 3 times the third hit you hold down and wait 5 seconds...you should see 100% on the dash. and its done GOOD LUCK!
SOURCE: how to reset 2006 toyota sequoia after change oil
Previous Post dead wrong...
Turn ignition to "ON" position. Make sure odometer is on trip setting not on total vehicle mileage setting.
Turn ignition OFF
Push and hold odometer button while turning ignition to "ON" position. HOld for about 4-5 seconds until maintenance light goes off. Turn ignition OFF. Start up vehicle. There should be no more maintanence light.
278 views
Usually answered in minutes!
×