At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
The key is there but the alram isn't. How do I turn the car on?
The alram broke in pieces but I have the key. The security alrm will not allow meto turn the caron. Is there another way to turn on the car but the key only?
Re: The key is there but the alram isn't. How do I...
Hi Tony, Take up the broken pieces and if there is a battery in the key connect it to the broken pieces, insert the key holding the broken parts in the same relative position and start up. Get the key replaced asap. Regards John
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
i would say when the person broke into your car they set off the security system which stops the car from starting, the way to reset the security is to put your key into the ignition turn the key until all the dash lights come on and let them stay on about 15 minutes after the 15 minutes have expired turn the key off and wait about 3 seconds and then your car should start. hope this helps.
The pass key system isn't working. Make sure your using the same key.There is a piece where a wire brakes in the steering column. Part is cheap but steering wheel needs to be pulled. And dealer needs to reprogram it.
security light comes on if the chip in your key isn't reading.. Possible issue are the pickup in the key cylinder is getting old and weak. a resistor that matches the reading of your key can be added to the bottom of the steering column where the orange wiring goes into a two pin connector and it will allow yo o bypass the security so it will start
This is your security light. When you lock your car you will see it stays solid and after about 30 seconds it will blink again. That means your alarm is armed on your car. When your car is off and it blinks that means it's ready to arm. Think of it like an alram in your home but it's in your car. But when your key is in the ignition the alarm is shut off until your key is taken out of the ignition. I hope this answers your question!!
You will have to use a key to turn one of the door locks or the trunk lock, in order to turn off the factory security system, which will then allow the car to start. If it's an aftermarket alarm you have installed in your car, you will have to consult the user manual for that particular alarm in order to disarm it.
You need to hook the alarm back up and do a reset on the car.
Here is how you do it.
1) Turn factory original key to "ON" position for 5 seconds 2) Turn key to "OFF" position. 3) Repeat 1 and 2 again. Do it twice. 4) This should reset the computer to the chip inside the key.
If that didn't work,You will need to have the codes downloaded at the dealer.
×