How do the vacuum lines hook into an acuator on a 1997 ford expedition

SOURCE: hooking up wires to battery, solenoid, altornater and starter

hi from the uk if you look at startermotor solenoid you will see two large threaded terminals with nuts? and a third small terminal either spade or round terminal ok? now you should see thet one of large terminals already has a metal or braides strap secured to it and the actual startermotor body? LEAVE THIS ALONE the other large terminal is the one you fit the positive+ lead to from battery also there should be another lead to also attach to same terminal this one supplies power for vehicles electrics etc ensure you secure these with nut ok? now the third small spade or post terminal you will hav a thin wire nearby ?this attaches to thisterminal on its own on solenoid this wire is the one that activates starter when ignition is turned to key start position ok? as for interior light not working ? try again when you complete the above also make sure bulb is ok? ps! before you reconnect starter wires ensure the earth/ground lead is disconnected from battery and when reconnecting battery connect positive lead first then the earth lead or if you try other way you will have sparking from pos lead as you try connecting to battery hope this info is clear instructios for you to follow and wish you luck best wishes from england

SOURCE: 1987 Ford Ranger 2.0 Liter Vacuum Line Diagram

can you see the diagram under the hood? if not try searching a junkyard for either the diagram or a complete motor

SOURCE: need vacuum diagram for 4-wheel drive

the 4x4 don't use vacuum. the front is auto lock when the transfer is engauged with the button. if the light don't which when pressed into 4hi or 4low. the motor on the transfer case maybe hung up. they have to be used at least 4 times a year not to go bad. the motor is on the back side of the transfer case. best of luck.

SOURCE: 4 wheel drive system for 1997 ford expedition

I TURN THE 4X4 SWITCH AND NOTHING HAPPENS

SOURCE: I need the audio wiring diagram for 1997 ford

1997 Ford Expedition Car Radio Wiring Diagram
Car Radio Battery Constant 12v+ Wire: White/Purple
Car Radio Accessory Switched 12v+ Wire: Black/Pink
Car Radio Ground Wire: Black/Green
Car Radio Illumination Wire: Blue/Black
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: Blue
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: 6′ x 8′
Car Audio Front Speakers Location: Doors
Left Front Speaker Positive Wire (+): White/Red
Left Front Speaker Negative Wire (-): Brown
Right Front Speaker Positive Wire (+): Green
Right Front Speaker Negative Wire (-): White/Orange
Car Audio Rear Speakers Size: 6′ x 8′
Car Audio Rear Speakers Location: Rear Doors
Left Rear Speaker Positive Wire (+): Light Blue/Black
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Purple/White
Right Rear Speaker Negative Wire (-): Light Blue

pls rate