SOURCE: how do i reprogram my02 ford focus remote locking key fob please.
get in your car close door hit the unlock button then put key in the ignition cycle the key from off to on (STOP BEFORE START POSITION) cycle key off to on 7 times after the 7th trime the doors should lock the unlock automatically that means u are in trainning mode hit the unlock button on key fob. the key fob should now work if it doesn't then try changing batt
SOURCE: 2004 Ford Escape Electrical problem
This is a problem with the alternator. Diode rectifiers and voltage regulator replacement will give this baby a 14.2 voltage output. In this 3L V6 SUV removal of the alternator requires removing the right tire, the right axis and undercovering to reach the 6G alternator. It is a 133mm rectifier with a motorcraft, The serpentine belt is better removed from the bottom. Also keep a bucket on hand to recover the oil from the transmission.
SOURCE: RADIO WON'T TURN OFF WHEN KEY IS TAKEN OUT OF IGNITION
The other item is could be, if not a defective door switch, is some of the new MY trucks develop broken wires from the door to A-pillar.
This should be a black w/ yellow stripe wire in the harness between the door and a pillar. Not very common, but has happened more then once.
SOURCE: problem with ford explorer alarm imobiliser
You should have a switch under the dash and then just turn it to the off position. If you don't or it doesn't work (like mine) then, there is 2 fuses under the dash, put the key in the ignition and turn it forward, pull one of the fuses out and then start the car that should reset it. Then you should be able to put the fuse back. Sometimes if you put the fuse back before starting it the alarm will just continue to try and reset itself, but not start the car. If that doesn't work I have a mechanic who can pull the whole alarm out and when hes done it would look like nothing has ever been installed. Hes very good. I ended having him take my alarm out when I had the same incident happen after the 2nd time.
SOURCE: Interior Light sometimes will not shut off in Ford Ranger Pick up
If I am not mistaken, the plunger is located in the door with the latch. Most of the time you can just pull the door panel off and adjust the switch. After opening and closing the door, they get knocked out of adjustment. I sincerely hope that this helped you. Take care and best wishes.
Bryon
Go sit in your truck and close all the doors. Light stays on right? Put your key in the ignition. Does the chime start going off when you put the key in? If so, door switch or the GEM thinks a door is open.
To find out which door... Leave the key in the ingntion. Turn to the on position. Even with doors closed, chime sounds once after a few seconds and door ajar light comes on and stays on right? Open each door one by one. The chime should sound each time you open a door. When you find the door that doesn't make the chime sound when you open it, that is the problem. (Don't forget to try the rear hatch and the hatch glass also!) To determine if the switch is bad or if the GEM is having a problem thinking the door is open, just unplug the suspected switch, close all the doors, and see if the problem stops. (don't forget to wait a second to give the lights time to go off) If unplugging the switch solves it, the replace it. If it doesn't, Ford can check your GEM to see if it is the problem.
I hope this helps
584 views
Usually answered in minutes!
×