Kia rio 2002 camshaft pos. sensor just replace still light check

yes it has a crank position sensor located in front side for engine block near bell housing area

replaced crank and cam sensor [Archive] - Sorento Nation - KIA ...

www.sorentonation.com/forum/archive/index.php/t-913.html

20 posts - ‎6 authors
replaced crank and cam sensors put back together cranked up very rough idle some tapping any ... 12-17-2012, 12:24 AM ... It's a 2006 3.5 Kia Sorrento. ... I found theproblem the SUV has a aftermarket alarm and remote start system I tripped ...

Kia Rio Crankshaft Position Sensor Replacement - YouTube

? 4:44
https://www.youtube.com/watch?v=hihQxMWuSFY
Mar 21, 2014 - Uploaded by Jason Roush
While looking for how to replace a Kia Rio crankshaft positionsensor, ... is on and i have a P0340 code, think this is theproblem? kia rio 2002.

Kia Sorrento/Sedona: 3.5 Litre Engine/Timing Belt/Crank ...

? 20:23
https://www.youtube.com/watch?v=CjaD_zYPrUA
Mar 29, 2014 - Uploaded by JamieJones TheCarMan
Repair and/or Replacement tips for timing belt, crank sensor,cam sensor, water pump and drivebelt ...

Crankshaft position sensor - 2003 Kia Sorento - RepairPal

repairpal.com > Questions > Kia > Sorento > 2003 Kia Sorento

There will be a camshaft and crankshaft sensor so be sure you replaced the correct one. The code its giving you is a dead sign of no start and a bad sensor. Make sure its electrical connector is hooked up tight and its seated properly.

Check the wiring, animals love chewing on wires.

I would guess a wiring issue. Check all the cabling and make sure all connectors are nice and snug with no signs of corrosion or burnt.

the check engine light comes on to tell you there is a problem with something the computer controls or receives info from. Have the computer scanned for codes. Once you have those codes post them here and I'll be happy to help you further.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Front brakes would cost aprox: $180 or less for rotors+pads for the front. If you do it yourself. Hope this helps!

I have a 2004 kia rio have replaced the camshaft position sensor twice, and the code keeps coming back after it is reset. It is still running really rough. Is there something I am overlooking?

Did you reset the code after replacing the sensor? If it is accessable you may want to try to wiggle or hold the camshaft position sensor while cranking to see if this helps. On most of the vehicles I have had a problem with this sensor, most won't even crank when there is a sensor issue. So you may have another problem on your hands.

check the fuel line hose near the fuel regulator for wear as they tend to leak or corrode causing a gas smell inside the car. My 2000 Kia Sportage just had the same problem with the gas smell inside the car.