SOURCE: LOUD NOISE FROM REAREND
remove the the diff unit and refit into your casing ,,,easy job,Preload on pinion bearings and set crownwheel backlash to a very small wiggle woggle.handful of LM grease in unit before you refit cover then use ep90 gear oil .job done shouldnt take more than a morning to do.
SOURCE: 94 toyota previa brake lights not illuminating
CHECK THE BRAKE LIGHT SWITCH UNDER THE BRAKE PEDAL
SOURCE: toyota yaris brakes how do you bleed the brakes on a toyota yaris
have someone pump the pedal and hold it, then you work from the right rear, left rear, right front, left front, while the person pumps and holds several times at each wheel.
SOURCE: where is the flasher on a 1994 toyota previa
The flasher is bolted to the firewall behind the right side of the instrument panel and you can't get to it from underneath the instrument panel. You will have to remove the center console fascia to get to the instrument cover screws and remove the instrument cover. Then you can get to the instrument holding screws and move the instrument panel out of the way. Either a service manual or AutoZone.com will have this information and pictures. Replace the flasher with a genuine Toyota flasher relay. The aftermarket relays might look like they fit but I have found out they don't work properly. The flasher is bolted to the firewall with a 13mm bolt. Take out the bolt and replace the flasher.
SOURCE: how to change front brake pads on toyota previa
open master cyl cap
remove tires
remove 2 bolts holding caliper
push piston in (GET THE C CLAMP)
change pads
403 views
Usually answered in minutes!
×