3.3 AND3.8 ENGINES TAKE OFF SERPENTINE BELT 15MM ON BELT TENSIONER . REMOVE 2 HOSES OFF PUMP. 5 ?BOLTS AROUND WATER PUMP. IT WILL COME OFF WITH ANTIFREEZE LEAKING OUT. HAVE DRAIN PAN UNDER . ALSO IT IS GOOD TIME TO CHANGE THE LOWER HOSES. REINSTALL WITH NEW GASKET, FILL SYSTEM, PUT HEAT ON HOT AND RUN UNTIL THERMOSTATE OPENS, AND CHECK FOR LEAKS, TORQUE IF NESSESARY ( ENGINE OFF)!!REFILL AT SIDE TANK
SOURCE: Location of clock spring on 2000 Grand Voyager
The clock spring is located under the steering wheel, the airbag must be disarmed (if not done correctly can can serious injury) and the steering wheel removed to replace it, a dealer will charge about $200 for this repair.
SOURCE: chrysler 2000 grand voyager The fans under the
You either have a bad relay, bad temp sensor, or bad PCM. I would start with the relay as these give the most problems.
SOURCE: replacing radiator fan motor on 2000 chrysler grand voyager
Disconnect the wires leading to both of the fans. Remove the cross-member that goes over the radiator. Remove the four bolts securing the fan assembly and lift it out.
SOURCE: changing fuel pump on chrysler 2000 grand voyager
you have to drop the gas tank out from under the vehicle. You must first drain as much gas out of the tank as you can. Then support the tank with a jack. Preferably with a large plate. Then remove the retaining straps. If you can remove any of the fuel lines and fill nozzle before lowering please do. If you cannot, lower the tank until access to wiring harness and fuel line disconnects can be made. With a special fuel line tool remove lines and harness and anything else that may hinder the removal on the tank. Once the tank is out from under the vehicle remove as much dust and debris as you can fom the top of the unit. Remove the retaining ring using a hammer and a punch, or screwdriver. Once the retaining ring has been removed carefully remove the fuel pump assembly from the tank. be careful not to damage the float. replace pump in the reverse order above.
SOURCE: fit a water pump on a grand voyager
Dear Waterpump Fitter,
These voyagers are actually fairly easy to install the waterpumps on, The pump is located on the passenger side of the vehicle closer to the front (towards the bumper) It should take the first or second timer maybe a couple of hours to install.Please et back to me if you have any other questions..I'M HERE TO HELP!!
211 views
Usually answered in minutes!
×