How to can i replace stereo - 1996 Toyota Tercel

1. Check the wiring: Make sure that all the wires are properly connected to the stereo and to the car's electrical system. Look for loose, disconnected, or damaged wires and repair or replace them if necessary.
2. Check the fuse: The car stereo may not be receiving power if the fuse that protects it has blown. Check the fuse panel in the car and replace any blown fuses.
3. Check the battery: If the battery is dead, the car stereo won't receive power. Charge or replace the battery if needed.
4. Check the ground wire: The ground wire is essential for the proper functioning of the car stereo. Make sure it's properly connected to a clean, unpainted metal surface in the car.
5. Check the wiring harness: If the wiring harness is damaged or not properly connected, it may prevent the car stereo from receiving power. Replace the wiring harness if necessary.

Find some youtube tutorial videos like this:


How to remove car stereo



Replace Your Car Stereo in 7 Steps




Swap out your car stereo




How to Install Replacement Car Stereo

Don't know if works for Yukon Denial but thare are some interesting tutorial, one of them might serve:


How to Install Replacement Car Stereo How to Install Replacement Car Stereo


Replace Your Car Stereo in 7 Steps



How to remove car radio without special tools keys sony cdx R3350



How to Remove and Replace Car Stereo Radio Panasonic



How to remove car stereo

Disconnect the negative battery cable from the Jeep Cherokee battery with the 10 mm wrench.

2 Remove the five screws on the top edge of the dash panel with a Phillips-head screwdriver.

3 Pry the trim panels surrounding the climate control knobs away from the dashboard with the trim panel removal tool.

4 Remove the trim panel that surrounds the headlamp switches (located to the left of the steering column) with a trim panel removal tool.

5 Remove the two screws behind the trim panel that surrounds the headlamp controls with a Phillips-head screwdriver.

6 Pull the dash panel that surrounds the stereo and covers the instrument panel of the Cherokee, away from the dashboard by hand.

7 Remove the two screws from the stereo mounting bracket. One screw is on the bottom left corner, the other screw is on the top right corner. Each screw can be removed with the 10 mm socket and drive.

8 Pull the factory stereo from the stereo mounting dock.

9 Disconnect the stereo wiring from the back of the factory unit.

10 Connect the Jeep Cherokee factory stereo wiring to a wiring harness adapter. Connect the wiring harness adapter leads to an aftermarket stereo. Slide the aftermarket stereo into the stereo mounting bracket and replaced two screws at the opposite corners with the 10 mm socket and drive.

11 Replace dash panel that stretches across the top of the steering column.

12 Replace the two screws at the top of the headlamp control switch. Replace the trim panel around the headlamp switch.

13 Replace the trim panel that surrounds the climate control knobs.

14 Replace the five screws on the top edge of the dashboard with a Phillips-head screwdriver.

15 Replace the negative battery cable over the negative battery terminal and tighten the cable to the negative lead post with the 10 mm wrench

They make adapter kits for this. Try crutchfield

should go to any local junkyard to get the stock harness, or you can decipher and splice each vehicle wire to the appropriate wire on the stereo. If it was me, i'd go the junkyard route, much easier in the long run.

Contact this business they are the best around. Find what fits your car Crutchfield

just try to get the stereo supply directly from the battery,don't forget to put fuse on it..otherwise check if there were any relays from the stereo supply..check if it needs to be replace for higher wattage/amp..

The lcd screen could be replaced, but it is a very technical job involving stripping down the stereo and a lot of fiddly soldering. And finding the correct screen out of another stereo. Much easier and probably cheaper (unless you can do it yourself) to replace the entire stereo.

hi
im dave
your vehicles stereo is equipped with an antitheft system that render it inoperable once removed. If you are replacing with another ac delco make sure you have the code for that stereo. If you are replacing it with after market then find the section in your owners manual that tells you how to set the code, set it and write it down (maybe on the stereo) so you can sell it as those factory ac delco stereos are quite pricey