Fuel level sensor

T.p.s sensor problem..

https://www.autozone.com/repairguides/Suzuki-Forenza-Reno-2003-06/Gasoline-Fuel-Injection-Systems/Fuel-Pump/_/P-0996b43f8037a116

This will show you where your fuel pump is BUT that may not be your problem. You should hook up a manual fuel pressure gauge to your fuel rail and watch what the fuel pressure does when it dies.I If the pressure does not drop then you have a different problem like a tps switch loosing connection tho the throttle body or fuel pressure regulator. http://www.fixya.com/cars/t8631798-change_fuel

Sam the A/T trans in all cars is the most complex of all
I know it seems simple until it breaks.
or until actual fix one.
tell us with the trans does good and bad in ALL GEARS
slips or flairs
skips gears
will not up shift to gear ? name gear
will not down shift, same.
noises odd. or vibrations.
will no move. car at all

get it serviced
check level using operator guide method do not guess.
check fuse
scan it yet

depends on location, like all things made.
also on , new, used, and rebuilts.

i get mine from CARDONE.
in usa, about $400 exchanged (avg)

look at both sides of engine.
one side has a starter. (all engines)
if not on front, side, that means it other.
exhaust side or intake, side, look both?


2.0L
sold gas and diesel , ill toss coin, lands on gas.
2.0 L Family II I4 (petrol) GM engine. L34 ! Daewoo X20SED
2.0 L RA 420 I4 (diesel)

all this is on alldata.com
or the 4 buck suzuki page
https://suzukipitstopplus.com/Products/1064-2005-forenza-reno-service-manual.aspx

gas is twin cam belt drive
The L34 also known as the U20SED is a 2.0 L

so lets use real names for engines, (daewoo/gm mixed up)
L34

one way to see parts, on and engine, is pretend to buy one used
bingo?


see cam belt.
see intake side, bingo>?
see stater hole there????? gapping wide.




Easter egg hunts,
did you know you are not helpless.
the dealer pages show all parts
http://www.suzukicarparts.com/parts/2005/Suzuki/Reno/?siteid=214820&searchText=

and alldata.com it there too.


and the real FSM , is there too... posted 100s of times.
$4 to look. best deal of any car maker....
https://suzukipitstopplus.com/

and suzuki is chapter 11 here, so sell it.?
if in USA./ sell it. I would.

a tune up. did you do the service on the car.
filters, spark plugs?
did scan it, to see what DTC errors are set? that is required.
and 02 sensor can die at 100,000 miles the design life span. "bosch"
which engine, option.
1.4 L I4 (petrol)
1.6 L I4 (petrol)
1.8 L I4 (petrol)
2.0 L I4 (petrol)
2.0 L I4 (diesel)
we can not help you , unless. engine is stated and country.
www, the world wide web, make it so we can NOT guess any of that.

the ECU/PCM on your car goes to GREAT efforts to prevent stalls.
the top reason for stalls are:
1: never doing the service per listed items in the glove box guide.
2: EGR stuck open. (if your's has one, some dont)
3: lean air fuel mixture, (lots or reasons and tests)
4 gross rich air fuel mixture casing gross misfiring and stalling.

or something worse. there is always that. eg: burned head valves. etc.

Should be under the valve cover

http://www.2carpros.com/questions/suzuki-reno-2005-suzuki-reno-cam-shaft-position-sensor-location

Here are you timing marks contact if you need more help.http://www.2carpros.com/car_repair_information/tec_info/2005/suzuki/reno/2005_suzuki_reno_timing_belt_diagram_marks.htm
Thanks for using FIX YA