2008 Chevrolet Silverado 1500 Logo

Related Topics:

A
Anonymous Posted on Sep 21, 2012

Check engine light is on and remote starter not working

Used remote starter then check engine light went on then the remote starter will not work

1 Answer

taterhead 3e

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Champion:

An expert who has answered 200 questions.

  • Chevrolet Expert 200 Answers
  • Posted on Jan 07, 2019
taterhead 3e
Chevrolet Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Champion:

An expert who has answered 200 questions.

Joined: Jan 24, 2009
Answers
200
Questions
0
Helped
280748
Points
466

By a cheap odb2 reader read code then delete codes,,with no check engine light on it will crank with remote start ,,a few times,,,,or til the light reappears ,,,you can also take the neg cable off the battery for 30 seconds to clear the codes,,, remote start should work after that if no engine light

4 Related Answers

Anonymous

  • 4 Answers
  • Posted on Nov 29, 2008

SOURCE: CHECK ENGINE LIGHT

Any time the Service Engine light comes on the remote start is disabled for the engines safety. As far as the SES light, your dealer should be able to help you with the diag.

Ad

Anonymous

  • 23 Answers
  • Posted on Jan 05, 2010

SOURCE: 2007 Chevy Silverado when my check engine light

It's a safety feature. For example, if there is no oil pressure when you start the engine, you could not see that unless you were in the car and could spin a bearing or seize the engine by starting it remotely and letting it run unattended. So when the check engine light is on, there is something not working properly with the engine/engine management system and it wants you in the car where you can see the guages and turn the engine off immediately if there's a serious problem.

Anonymous

  • 5 Answers
  • Posted on Feb 05, 2010

SOURCE: remote start does not work

henryj153, no offence guy, but if you dont know something, dont try and give advice. Now for the guy with the problem mattpointer:
These cars come with remote start as an option, and it is problably your BCM (Body Control Module), which is a $380 part, and the dealer has to install it, because of the programing... Here is a free way of checking if that is it. This part ties in certain vehicle systems, and for some reason when the BCM goes bad, so does the GPS, that is tied in with OnStar Check to see if your onstar can recieve GPS... press the blue OnStar button and ask them to locate you. If you dont have the service, they may want to start the service, just humor them as if you were interested, and ask them to locate you first, because you want to make sure the equiptment works. If they cant locate you, but you are able to use OnStar to contact them, most likely The BCM is bad, and thats what it is. This car has some great technology, but the intergration of this tech is in the BCM, and it goes bad.... so its a trip to the dealer for you my friend.

happycouple7

  • 189 Answers
  • Posted on Apr 14, 2010

SOURCE: on my 2006 HHR my temp guage doesnt work nor does

sounds like the temp sensor is bad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

What does a p0411 code mean?

That code means. Secondary Air Injection System Incorrect Flow.
1helpful
2answers

Why motor will not turn using remote GM/L:22733524?

Hi! So are the other functions working? Locks, panic button, trunk, and does the remote start light come on when you try to start the car?
0helpful
1answer

Remote starter won't start engine, now check engine light is on

Need more information. Does the car start normally with a key? Is there a switch for a mechanic to disable the remote start while working on it (some units have a toggle switch)
0helpful
1answer

2002 buick Lesabre (Limited) - When operating the AC I have warm air coming out of the on driver's side vents and cold air on coming out the passanger side vents.

check battery,battery cables,starter,starer solenoid, check if your battery have any power left, by turning lights on, if light is strong then on the starter motor,remove the remote wire, the thin wire connected to the starter from the ign. switch, instead of the remote cable, try to by pass it, with battery voltage, with ign switch on on pasition, if your starter works the starter is good if not change the estater, if starter works then check the remote wire, could be damage, could be the starter switch, fuse , or the starter relay. when working on car always make sure if the engine starts there is rotsting components. Thanks
2helpful
1answer

I have a 2008 impala the remote start will not work the re mote locks work and there is no check engine light on

your remote starter has 2 fuses, please check them both. if they are good, your remote starter is at fault
8helpful
2answers

My remote starter will not work. It is factory installed. It is not the clicker and yes, the check engine light is on

The remote start on this vehicle will not work if the check engine light is on.You will have to have the codes checked and repaired in for the system to work.You should also check to see if you are still under the factory warranty.It is 3 years and 36k miles.If you are over this then you are not under warranty.Hope this helps.Good luck.
0helpful
2answers

2007 cobalt remote starter opens doors but does not start car

Ok help me understand this. When you say "remote starter" are you refering to the Keyless Entry remote. Assuming your car is equipped with remote start from the factory, if you check engine light is on the remote start is disabled. Is your check engine light on? Do you have multiple Keyless Entry remotes? See if the other one works if you do? It is possible that perticular button on that remote is not working while others are working. You will need to replace it at a dealership.
1helpful
3answers

Engine won't start

The fact the engine rotates indicates a good battery, that's eliminated from the search.
The problem is of Main/Auxiliary Power Supply. Trace the Main Battery cacle from the Starter, if it has more than 1 Power cable attached, looking for a connector break running back to the Power Box. If the Starter has only 1 supply cable, then look for a loose joint on that Battery to Power Box Connector Block, or broken 'Spade' connector. If again all appears ok, by using the "Idiot" diagram, on the Power Box and Fuse Box, pull each Maxi and Service Fuse and Relay in turn, looking for a Failure. Should this not detect the fault come back to me again.
Regards,DT
Not finding what you are looking for?

8,462 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...