SOURCE: speed sensor
it should be located under the car on the tansmission gearbox but it is covered by a Sheild and will be hard to see.
Here is a clipping from a web forum that explains how to remove and reinstall a speed sensor ina 94 Taurus ....
The source listed below explains how to remove and reinstall it, and should also halp you locate it:
http://www.automotiveforums.com/vbulleti...
SOURCE: bad speed sensor need to be replace
just remove the 5/16 bolt and pull sensor of and reinstall new one,
bolt is kind of tie to get to but ones is out it will be simple
SOURCE: Skip or Miss at low speed acel
do a minor tune up .replace distributor cap and rotor.coil spark plugs and wires.change fuel filter.check for intake leaks.at vacuum hoses.check air duct going to the throttle body.if tune up dont help.check engine compression.for weak cylinders and worn valves.
SOURCE: 96 ford taurs VSS
The trick is to snake your arm down the back, ajacent to the maifold pipe, and unplug the wiring harness. Should be a 10mm socket to unscrew the bolt that holds the sensor in place. Once the screw was out it was easy to pull the sensor out and rush to Auto Zone and get a new one. Reverse the process in putting the sensor in.
SOURCE: i cannot find the transmission speed
your looking for the turbine speed sensor a.k.a transmission speed sensor and not the vechile spees sensor correct? they are two different sensors! the transmission speed sensor is on the side of the transmission facing the side of the car around 11 o'clock in relation to the output shaft witch is where the cv axle goes in! if it is the vechile speed sensonr then it is on top of the transmission tail house for the other output shaft and the other cv goes too. if you follow the transmisssion dip stick down to the transmission it is in that area! good luck
360 views
Usually answered in minutes!
×