SOURCE: knock sensor 1996 v6 3.3 nissan pathfinder
The Crankshaft Position Sensor is located:
Under hood, driver side, front engine area, mounted rear of crankshaft pulley
The Knock Sensor is located:
Under hood, center, front engine area, below intake manifold, mounted on block
SOURCE: Nissan Quest/Knock Sensor
n ot enough info to determine....... now what speed sensor.. one is the vehicle spped sensor to operate the speedodometer.. the other is for the engine speed for timming of motor..
SOURCE: crankshaft sensor location
The diagram shows it to be to the right of the oil fill cap down in the bellhousing when viewed from overhead,two wire connector.Looks like it might be right next to or under the motor grab hook..look for black/yellow and light green wire at connector..Good luck.
SOURCE: Diagram available for 01 Nissan Xterra Knock Sensor location?
V6 3.3L The sensor is located underneath the air intake manifold on top
of the engine block. This should take an experienced mechanic about 3-4
hours to replace.
Fig. Engine compartment component locations
Hope this help (remember rated this free help) Good luck.
SOURCE: where does the knock sensor is located
you have to remmove the intake and it is on what looks like a bracket that bolts to both heads is the knock sensor
833 views
Usually answered in minutes!
×