Fuse blown, replaced fuse, blew again tried different excessories. Still blows fuse?
Hi
Check fuse 3 20amp fuse in the fuse box.
Technica Support ' Hotmail Support
SOURCE: 98 jeep tj, dash light/taillights/licence plate light don't work
disconnect head lights, and replace fuse. Then turn the light back on to see if it blow a fuse again. if not, plug on light in at a time. You might have a bad headlight???? then unplug that one if nothing happens. Then plug the other one in. It could also be a bad taillight bulb. I have had bad tail light bulbs. Do all of them, one at a time.
SOURCE: cigarette lighter fuse
Click on the link below to open fuse map, it is fuse nr 2:
1993 - 1994 -1995 Fuse
& Circuit Breaker Identification
SOURCE: cigarette lighter doesn't work
before u pull panel, check for 12vdc with voltmeter inside lighter socket. If u have it, then clean contacts and/or replace lighter(not socket, wiring is fine) May save a lot of work. If you don't have voltage are you 100% sure you have right fuse and not the one below, above, or next to it? I still make mistakes with numbered fuses, which number is for which fuse. To make sure I start counting at 1.
SOURCE: 2006 jeep liberty cigarette lighter problem
its probably not the lighter itself, it's probably lost power. check the fuse for the cig lighter and see if blown. if it is, replace. if it blows immediately you have a dead short. if not, pay attention to when it stops working. could be a problem with whatever you are plugging in, or something else on the circuit
SOURCE: jeep keeps blowing auto shutdown fuse
Yes I had the same problem. The wires that plug into the sensor at the catatytic converter were rubbing against the drive shaft untill they finally wore through causing the short against drive shaft. repaired wires and it fixed everything
1,311 views
Usually answered in minutes!
×