Glass & Regulator
Fig. View of inner door frame and window regulator assembly
-
Lower the window glass and remove the door panel.
-
Carefully peel off the door screen so that it can be reused.
-
Raise the window enough to reach the regulator bolts, hold the glass underneath and unbolt the glass from the regulator.
-
To remove the glass, raise the glass by hand and tilt it as necessary to remove it from the track.
-
To remove the regulator, lower the glass carefully to the bottom of the door and remove the bolts to remove the regulator.
-
Installation is the reverse of removal. Tighten all bolts to 61 inch. lbs. (7 Nm).
Fig. Installing the door glass regulator
Motor
-
Remove the door panel.
-
Carefully peel off the door screen so that it can be reused.
-
Unbolt the window from the regulator and carefully lower it to the bottom of the door.
-
Disconnect the wiring and remove the motor mounting bolts.
-
Remove the 3 guide rail bolts and lower the motor and guide rail assembly out the bottom of the door.
-
Installation is the reverse of removal.
NOTE
The upper cable must be below the guide rail mounting bracket.
Showing window regulator motor, or assembly carrier with window regulator, removal/installation
Fig.
NOTE
The illustration shows the removal and installation of the window
regulator motor/assembly carrier with the window regulator on the rear
doors. The procedure for removing and installing on the front doors is
the same.
Fig. Slide a hammer shaft between the window guide and the
assembly carrier until the end of the hammer shaft presses against the
assembly carrier. Remove the screws and take off the window regulator
motor
-
Slide a hammer shaft between the window guide and the assembly
carrier until the end of the hammer shaft presses against the assembly
carrier.
-
Remove the screws and take off the window regulator motor.
To install:
-
The gearing will move when the window regulator motor is removed;
it is then no longer centered. The gearing must be aligned when the
window regulator motor is installed until the window regulator motor is
centered again.
-
Installation is the reverse of the removal (see illustration).
Motor & Regulator
NOTE
The illustrations in the procedure show the replacement of the
window regulator motor/carrier assembly with window regulator for rear
doors. The procedure for front doors is the same.
-
Remove the front or rear carrier assembly.
-
Slide a hammer handle between the window guide and carrier
assembly until the hammer handle end presses on the gears of the carrier
assembly.
-
Unfasten the bolts (1) and remove window regulator.
Fig. Unfasten the bolts (1) and remove window regulator
To install:
NOTE
By removing window regulator motor, gearing shifts, it is not centered.
Fig. By removing window regulator motor, gearing shifts, it is not centered
-
When installing window regulator motor, the gears must be aligned until the window regulator motor is centered again.
-
Attach and tighten the bolts to 3.5 Nm. The bolts must be
tightened to specifications, or damage to plastic sleeve on window
regulator motor can result.
-
Carrier assembly with window regulator, installing:
-
For replacement part carrier assemblies, the gearing is secured in place with a cable tie.
Fig. For replacement part carrier assemblies, the gearing is secured in place with a cable tie (1)
-
Slide a hammer handle between window guide and SF so far until hammer handle end presses on gears of SF.
-
Remove the cable tie .
-
By removing window regulator motor, gearing shifts, it is not centered.
-
When installing window regulator motor, gears must be aligned until window regulator motor is centered again.
-
Attach and tighten bolts to 3.5 Nm. The bolts must be tightened to
specifications, or damage to plastic sleeve on window regulator motor
can result.
Hope this helps to solve it.
×