Cars & Trucks Logo

Related Topics:

Anonymous Posted on Sep 10, 2012

Tail lights,dash lights,hazard lights not going,fuses all good.was wiring up a trailer when this fault occured

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 2 Answers
  • Posted on Sep 10, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Sep 10, 2012
Answers
2
Questions
1
Helped
1086
Points
6

You probabaly over loaded the curcuit board or you hook the wrong wrie and it went in a safe mode to keep from blowing a fuse

  • Anonymous Sep 10, 2012

    any idea how i can fix this or should i take to auto electrician.thanks.

  • Anonymous Sep 10, 2012

    sweet,thanks all fixed

×

5 Related Answers

Anonymous

  • 379 Answers
  • Posted on Jan 17, 2009

SOURCE: 2006 chevy trailer tail light fuse?

yes there is , under the hood in a fuse block on left side of engine compartment , will be a 10 amp trailer parking lamps fuse ( TRL PARK ),,, also on right side of dash will be a right trailer turn/stop fuse and a left trailer turn/stop fuse, just for your information . i don't know if it will be plainly identified , if not maybe your owners manual can help identify it . were rootin for ya .

J5

Ad

Anonymous

  • 1861 Answers
  • Posted on Nov 11, 2008

SOURCE: 2003 Sienna tail lights don't work when headlights are on

Look under the dashboard, next to/above the park brake pedal, for the interior fuse box. It has a black plastic cover. Remove the TAIL fuse, and see if it is blown. This should get you fixed up. Hope this helps, and Thanks for choosing FixYa.

Anonymous

  • 475 Answers
  • Posted on Dec 09, 2008

SOURCE: headlights and dash light dont work

You would have to check and see if you are getting any power out of the light switch. There is a seperate wire for the headlights and the dash lights.

Anonymous

  • 6 Answers
  • Posted on Jun 04, 2009

SOURCE: No tail lights on 1991 Chevy Silverado. fuse is good

sounds like a broken wire in the harness. look around the bumper area,sometimes along the frame. may have to peel back some tape covering. also if you have a trailer harness look closely at those.

Anonymous

  • 1 Answer
  • Posted on Apr 12, 2010

SOURCE: Tail light, backup light and dashboard light will not light up??

96 eclipse rs back tail lites and dash wont come on i changed the combination switch ,fuses,relays and bulbs and it still dont work what else can it be?

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do I rectify indicator lights not working at all, on a 2003 Toyota Prado (Petrol)

If the blinkers on the car are working when the trailer is not connected but they fail when you connect the trailer plug, it is because the LOAD of the bulbs on the trailer exceed the capacity of the BLINKER CIRCUIT of the vehicle. I would recommend replacing the tail lights on the trailer with LED tail lights. Did that on my travel trailer, and it solved the problem 100%
0helpful
1answer

2001 3500 chevy duramax all running lights,tail and dash lights not coming on..

The wiring diagrams on 2000 and newer models are not easy to read sometimes, but it shows a 30amp park lamp fuse and a park lamp relay. The relay is controlled by the PCM. There is also a 10amp Int - Park fuse. I think the small fuse is inside the passenger compartment and the large fuse is in the engine compartment box.
You may have to get a shop manual to get the diagrams to be able to check each circuit.
3helpful
2answers

2007 tail light fuse location honda crv

I had this problem with my 2007 Honda CRV -- all the lights worked EXCEPT the tail/running lights and the license plate light. The other tail lights worked -- brake, reverse, indicators, and hazards. Front headlights also worked, but when the headlights went on the back tail lights did not (not to safe for driving at night!!)
The fuse was #15 in the interior fuse box (under the dash driver side) with the label "small exterior lights" ( also check fuse #19 labeled "small lights main"). The cause of my problem, I believe, is a bad or lose wire in my license plate light.
0helpful
1answer

Went in the ditch and now the tail lights and dash lights don't work. Changed out fuse and now brake lights work but others still don't Any advice?

you are going to have to get under it and start looking for ripped wires or damaged wires. also check around your trailer hook ups. dont know what type of ditch you hit or how you went in or how it was pulled out. if you went through some sapling trees or brush you could have torn up wires. if you blew a fuse then you had to short out wires. if tail went in first then trailer connector is a good place to start.
1helpful
1answer

Tail light running lights, and liscense plate lights dont work, but breaklights, signal, and hazard lights work

The tail lights and licence lamp is all the same circuit, should be a brown wire to all 3, it sounds like its broken in the harness somewhere (especially if the front park lamps work, then the fuse and switch are good). Trace back from rear lights until you find power. Check for pinched wires or cut, or bulges in the wire indicating resistence. Also if you have wired in a trailer plug, disconnect it and retry. Trailer wires are very seldomly wired properly and cause lots of light issues.
0helpful
1answer

Dash lights do not work, is it a fuse? And if so, wich one?

The dash lights and tail lights are usually on the same fuse, look for the tail light fuse. You may want check the wiring at the rear of the vehicle, especially trailer light wires. If your truck has one of those add in connectors for trailer lights, that you plug into the wire harness, you may want to take that apart. They sometimes get corroded and short out.
1helpful
2answers

1999 ford crown vic dash light running light problem.

Check all the bulbs at tail end for parking and brakes, test grounds and harness for trailer. Check fuses. clean batery terminals, Re instal head light swich properly and make sure all wires conect.
Vitally
0helpful
1answer

01 MDX dash and tail lights don't work. It occured while pulling a trailer

likely a blown fuse from the trailer lights. At least I would say so for the tail lights, Dash lights seems a bit odd.
0helpful
3answers

Trailer light hook up problem

It sounds like your have may have your brake light and running lights crossed on your wiring harness to the trailer. Good luck and hope this help's
0helpful
2answers

No tail lights working on honda 2008 CR-V

try http://www.etrailer.com/faq-wiring.aspx. They have very good concise information that might help.
Take it back and have them check the wiring. It sounds like the converter is wired wrong or faulty.
Not finding what you are looking for?

348 views

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...