SOURCE: Plymouth Grand Voyager SE, 1997. 3.0 litre
check to see if you have life at the wiper motor plug.if not.you have a dodgy switch.
SOURCE: windshield wipers only work on high on 98 ford ranger
Try replacing relay for wiper with another same relay from fuse block from another working accessory.Had same issue on friends Ford Ranger. Moved relays and cleaned harness connection at fuse block. Works fine.
SOURCE: My wipers do not work on low and intermittent
the 89 may have a wiper control module that needs to be replaced... how many wires connect to the wiper motor? if more than two the module is built in. if only two then the module is re,ote mounted and probally under the drivers side dashboard
SOURCE: My 2004 Ford Expedition will
Can you hear the washer pump running when you operate the washer switch? The washer pump is in the bottom (side) of the washer fluid reservoir. You should hear it running. If not, you can disconnect the wire connector at the pump and use a test light to check to see if there is power and ground at the connector when you operate the switch. If there is power and ground, replace the washer pump motor. If there is no power or ground, you most likely have a bad washer control switch. (You have to replace the entire Multifunction Switch)
If you can hear the pump running, check for washer fluid pouring on the ground. If this is the case, you have a broken hose between the washer pump and the jets that spray on your windshield.
Also note that there is no way possible that your problem could be CAUSED by a fuse!
For more information on this subject, please review this article: Where's The Fuse?
259 views
Usually answered in minutes!
×