Moved from states to canada and need to install daytime running lights kit purchased from canadian tire onto my 2005 hyundai accent.
Watch the YouTube video and see if that answers the general questions. Click this link
SOURCE: Adding daytime running lights to a 2008 Toyota Sienna
http://www.siennaclub.org/forum/index.php?showtopic=3772
DRL's can be added simply by adding a 20 amp fuse into an empty slot in the fuse box.
SOURCE: Replace license plate light 2005 Hyundai Accent
A slightly better set of instructions might help you. Mine is a 2003 Accent. You have to remove the access panel that covers the lamps and the wiper control. Remove the phillips screws along the bottom of the panel (closest to the floor of the trunk when the lid is closed). Then remove the two screws that hold the brackets onto which the two strings are linked which are used to raise the rear deck slightly when the trunk opens. Next, there is a small cover underneath the rear wiper (about 2 inches square) that you need to carefully pry off using a small flat head screw driver via the indents on the lower side of the plastic cover. Inside you will find a 10mm bolt; use a ratchet to remove the bolt. Next, using a small flat head screw driver, carefully pry the middle section of moulding between the panel you are removing and the molding that covers the top portion of the back glass. There are two clips at the base of each middle moulding piece closest to the panel you are removing. Once those pop free, grab the panel at the bottom and firmly but gently pull away from the car body to pop free the two retaining clips holding the moulding to the car body. Finally, use one hand to grasp the panel from the bottom and the other to help help slide the panel "up" towards the glass (top of the car). The panel's top is flanged, and must slide up and away from the lip on which it sits. With the panel removed, grasp the white socket that holds the bulb and with gentle pressure turn it counter clockwise about 40 degrees and then pull the socket out. The replacement bulb is a type 168. Reverse these instructions to assemble, making sure in the end to push all retaining clips back into place until you hear them "catch" and hold the panel firm;y against the car body so that you do not get vibration noise.
SOURCE: 2005 hyundai Accent, can't shift out of park and no brake lights
may want to check the brake pedal switch located on top of the brake pedal arm. If all fuses looks good, replace the brake pedal switch, which can also cause to not shift out of park.
SOURCE: Need full time daytime running lights
Just hard wire the lights into anything that is hot when the car is running. If your looking for some kind of alternate solution please let me know. Also did you want them on also when the headlights are off? You can also hard wire them with a switch inside the cab and that way you can flip the switch whenever you would like.
Thank you,
Lee
Testimonial: "I solved the problem by pinning-out the connector for the headlight switch on the turn signal arm. It just took time, solder, and some electrical tape"
271 views
Usually answered in minutes!
×