Front a/c blower goes on and off
SOURCE: air conditioner blower motor resister on dodge grand caravan
in my 2004 grand caravan it's behind the glove box and left of the blower motor. disconnect the wires first then remove the 2 screws to pull out the resistor unit. First make sure you have removed the negative of your batterie. I had the same pm that prevented the blower motor to operate in any speed. I hope this will help
SOURCE: front blower motor on 2002 dodge grand caravan
it's the blower motor resistor , it's behind the glove compartment, just make sure you disconect the neg. for battery first, open the glove comp. and pull the rubber stops towars the center so you can let the glove comp. hang all the way to the floor , the resistor it's in front of you, disconect the two conectors there's one big with 6 0r 8 wires coming out and another with only two, take them out by pressing on the side of each one, remove it , put the new one on , conect the battery and your done. it's about $ 13.00 at o'riellys auto parts .
I hope this fix yor problem.
David M.
SOURCE: 2005 dodge caravan engine light code p 441
If you mean code P0441 - This Relates to Incorrect Purge Flow for Evaporative Emission System
SOURCE: how to change front blower motor in a 2003 dodge
Removal & Installation
CAUTION
The Supplemental Inflatable Restraint (SIR) system must be disarmed before removing the blower motor assembly. Failure to do so may cause accidental deployment of the air bag, resulting in unnecessary SIR system repairs and/or personal injury.
The blower motor is located behind the glovebox, behind the blower motor cover
Once the cover is removed, unplug the electrical connector and push it through the opening in the housing
The blower motor is secured to the housing with three small screws
To install:
SOURCE: Heater blower motor replacement -1997 Dodge Grand Caravan
Remove the cover plate on the passenger side of the heater box, 3-4 screws.
Unplug the motor assembly, remove 3-4 more screws that hold the motor in place and pull it down from its position. Get an aftermarket motor and installed it in the original housing with the original squirrel cage.
Installation is the reverse of removal.
181 views
Usually answered in minutes!
×