Question about 1992 Oldsmobile Ninety Eight Regency

1 Answer

Car spins,but won't turn over,after driving for a while

Only happens,when car is hot

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Oldsmobile Master
  • 85,206 Answers

Hello
The engine and automatic transmission in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM

Posted on Sep 02, 2012

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater does not turn on


If you have a gas hot water heater that won't stay on, check to see if pilot light is out and relight it if it is. If you have an electric hot water heater that won't stay on, then you should have an electrician check the wiring.
if you need an auto tool you can click here: chinasinoy.com

Nov 05, 2012 | 1990 Toyota Corolla

1 Answer

!996 toyota celica gt stalled while driving and won't start up again.


Bendix has gone out on the starter. Replace starter. The spinning is the starter but it would not have gone out while "driving" so you may have another problem once you replace the starter.

Sep 25, 2012 | 1996 Toyota Celica

1 Answer

My XL7 won't start.


It is possible for the starter to turn but not engage the flex plate. When this happens it sounds different and and will turn faster as it not turning then fine therefore reducing the load on the starter. If this is your case replace the starter.

Jul 30, 2012 | 2002 Ford Explorer

1 Answer

Driving in 105 degree temp, truck quits! What happened?


If the engine won't crank with compression in the cylinders, either the head gasket has blown or something else major has happened.
You will have to get it towed to a shop.
If it cranks normally but won't start, you have to figure out if it is a fuel or ignition problem.
Did the temp gauge show it was overheating before it died ?

Jun 30, 2012 | Cars & Trucks

1 Answer

Just finished driving car, tried to start it back up and nothing happens. Radio works fine, lights come up but car won't start.


if starter is not engaging or clicks then have battery load tested. if battery checks good then test the voltage draw on the starter,may be dragging when it gets hot.

Jun 03, 2012 | 2002 Kia Spectra

1 Answer

1993 Toyota Camry won't restart after driving unless waiting hours. The starter doesn't try and it's brand new. It always starts cold and if you don't drive it, you can turn it off and restart it over


i'me asumeing the batt is ok....turn on lights, do they dim when you try to start engine? if not .bad selonoid on new starter..was it rebuilt? it happens. Billy Starr

Dec 27, 2011 | Cars & Trucks

1 Answer

My 2002 Yukon Denali XL shut down while my wife was driving it on the highway.When I reached her the truck's battery was completely dead. I purchased a new battery and now there's power but the...


Define - It attempts to turn over but won't catch and run ???? When you turn the key to start does the starter engage an spin the engine ? This would be a crank no start condition . If the starter doesn't engage an spin the engine this would be a no crank no start condition . Sorry to ask but i have only been an auto tech for thirty years an have heard a lot of different discriptions for these simple actions . crank no start or no crank no start . Very different diagnostic procedures . So when you turn the key to start , does the starter engage an spin the engine ,but won't start an run ?

Jan 27, 2018 | 2005 GMC Yukon Xl Denali

1 Answer

I have a 97 Crown Vic/w police interceptor....I asked a question several days ago because of issuses I'm having with my car. The car starts sometimes, with no problems. Other times...it won't...


Sounds like its a starter problem,if you can pull the starter off take it to an auto parts store,

there are many locations that have equipment to put a load on the starter, and they will be

able to tell if its bad. once you pull the starter off, if you can check the teeth on the fly wheel,

if there is a dead spot, the starter could spin and not engage the flywheel. I hope it's the

starter. the bendix on the starter the teeth that engage the flywheel could also have dead

spot's. and not engage all the time. good luck!

Jul 27, 2011 | Ford Crown Victoria Cars & Trucks

1 Answer

I have a 1998 Ford Windstar. Got in to drive, turned the key to start and 'snap' something seems to have broke within the ignition lock cylinder... all of the accessories are on... the key...


This happened to to me with my ranger. I went and bought in ignition and a junk yard and no problems after that. That way your not out of a lot of money.

Jun 02, 2011 | 1998 Ford Windstar

2 Answers

Chevy blazer wont start 2002


if it turns over there are a cocuple of things to check. crankshaft sensor and the coil pack maybe the computer.id start with the crankshaft sensor

Jun 29, 2008 | 2002 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

Jonah Oneal

Level 3 Expert

14092 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...