'97 land rover disco entry of radio code

Hi welcome main problems are the abs valves causing the 3 dash lights (search 3 amigos online) a really badly sited compressor can cause air suspension models to fail giving the bags a slow leak the V8 is a solid engine but can have radiator expansion tank and cap failures
the other issue is electrics windows and door looms are problematic

You can get codes and information on code entry for a small fee from here, I have used them before: Ford Fiat Jaguar Land Rover Mercedes Visteon Radio Codes United Kingdom...

First you need to tell me which cylinder you are referring to and which land rover, defender, disco, rang rover. Sorry chat agen

First off, you never have to set foot in a
dealership in your entire lifetime

The O2 Sensor, I hope you changed
yourself. That was a 10 min job

Disconnect the battery and see if the code clears

Some O2 codes clear when the new sensor is installed

If you visit

MG ROVER RADIO CODES

They have code entry instructions there to view for free!

http://mg-rover-radio-codes.com

Free Code Entry Instructions can be found here

http://www.radio-code.co.uk/code-entry-help.php

If I recall from my 98 Disco 1, if you don't have the security code from the owners manual then you have to leave the motor turned on constantly for something like one hour to override the security block and code. I learned this the hard way and then finally found the codes hidden away in the glovebox. Initially I drove around for over an hour (I think it was) with the radio power on and it finally came back on.

1. Disconnect battery ground cable.
2. Raise and support vehicle.
3. Disconnect leads from solenoid and starter.
4. Remove starter mounting bolts, then the starter.
5. Reverse procedure to install. Torque mounting bolts to 32 ft. lbs.

I had a new cd player fitted to my 97 discovery and that did. Raido codes are free, providing you can prove ownership. Just visit a main landrover dealer, they got mine in about 10 minites.

Check the door switches for the interior lights and tighten the screws holding these on to make a good earth contact.Knock the door locks lightly with a hammer to get the insides loosened up and lube these with a penetrating spray.