Question about 2002 Toyota RAV4

1 Answer

Car drags upon slow down and **** upon movement

Car Drags jerks as it moves. There is a round light on the dash board "check engine" Scan result said PO161 and P1135, O2 sensor heater circuit bank 2 sensor 2 and air fuel sensor heater circuit response malfunction

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Toyota Master
  • 1,121 Answers

CODE PO161 IS REGARDING OXYGEN SENSOR BANK2 SENSOR2 WHICH IT IS LOCATED IN THE BOTTOM RIGHT SIDE OF THE CAT ON THE OUTPUT OF THE CAT.REGARDING CODE P1135 IS FOR AIR FUEL RATIO OXYGEN SENSOR MALFUNCTION BANK1 SENSOR 1. MY OPINION CHANGE THE SENSOR BANK 2 AND RESET THE FAULT USING A SCANNER AND DRIVE IT. I BELIEVE WILL SOLVE THE PROBLEM.

Posted on Aug 31, 2012

Ad

2 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Molson02536

Harvey N Tawatao

  • 3854 Answers

SOURCE: Check engine light came on.

P1135 means that your O2 sensor has gone bad. The O2 sensor on the Toyota's are called Air fuel sensor's. If you have a 4 cylinder engine, the O2 is on the exhaust down pipe before the catalytic converter, and if it's a V6 it the O2 sensor on the fire wall side along the down pipe from the exhaust manifold. (sensor 1, bank 1) Good luck and keep me posted, check the wire harness. The wire harness could have corroded or burnt from the exhaust, but most likely it's going to be a bad O2. Keep me posted ,be glad to help

Posted on Jun 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Po 161 and p1135


PO161 IS FOR OXYGEN SENSOR BANK2 WHICH IS LOCATED IN THE BOTTOM RIGHT OF THE CAT (PASSENGER SIDE ) ON THE OUTPUT OF THE CAT..
P1135 AIR FUEL RATIO OXYGEN SENSOR MALFUNCTION BANK1-IS NOT NEED TO RENEW IT. CHECK WHETHER YOU HAVE THE AIR FILTER CLOGGED,OR WEAK SPARK CABLES OR WORN SPARK PLUGS,AS THESE ARE THE CULPRITS WHICH CAUSING THE AIR FUEL MIXTURE BE OUT OF RANGE AND CAUSE THE OXYGEN SENSOR TO FAIL. MY LAST OPINION CHANGE THE OXYGEN SENSOR BANK 2 ( PO161)AND RESET THE CHECK ENGINE LIGHT USING A SCANNER AND DRIVE IT. IF NO LIGHT COMES ON SHOULD BE THE ONLY FAULT.

Aug 31, 2012 | 2002 Toyota RAV4

2 Answers

1996 Toyota 4runner 3.4L error code p0133


SAE J2012 Revised DEC2007 lists Diagnostic Test Code (DTC) P0133 as "O2 Sensor Circuit Slow Response Bank 1 Sensor 1"

This code basically means that the upstream oxygen sensor on bank one of your engine is not responding as quickly as it should to changes in oxygen leavels in the exhaust.

The usual causes of this is an oxygen sensor that is just plain worn out (if it has a lot of miles on it) or an oxygen sensor that is contaminated by engine oil or antifreeze leaks causing these fluids to be burned in the exhaust (like bad piston rings, defective PCV valve, blown head gasket, etc.).

In any case, the oxygen sensor needs to be replaced. However it should be noted that if it is caused by contamination like that described above, replacing it will only result in a new oxygen sensor doing the same thing if the cause of the contamination is not repaired.

Jan 24, 2012 | Toyota 4Runner Cars & Trucks

1 Answer

O2 malfunction P1135. Please what do i need to buy to replace ? Can I do this myself or will have to let an expert do it. i would be very grateful if you could tell me what EAXACTLY that I need to buy...


The P1135 code on your Toyota is Air fuel ratio sensor - heater circuit malfunction. Basically the problem there will be with the air/fuel ratio sensor (on other vehicles it is refered to as an O2 oxygen sensor), or the wiring/connectors leading to it. It could also be a problem with a fuse or relay on the heater circuit. Again, not a real difficult problem to solve.

just fixing the P1135 code will not cause the check engine light to stay off because there are other unrelated codes. If the code P1135 was causing the other problems then perhaps fixing that code would fix the others, but that's not the case here. The reality is you'll need to have all the problem areas looked at (IAT sensor, MAF sensor, Air/fuel ratio sensor) and repaired in order for your engine light to stay off. Normally if there are codes stored a vehicle cannot pass inspection. I would get a second opinion from another local mechanic as what you've been told may not be 100% correct.

Good luck.

Dec 05, 2010 | Toyota Highlander Cars & Trucks

2 Answers

Check engine light on reads p1135


On Toyota models the error code meansthe problem is as described below

P1135 Air/Fuel sensor heater circuit response (bank 1 sensor1).

It indicates the most common problem with your O2 sensor . Bank ! sensor indicates the upstream O2 sensor. It might be faulty and needs to be replaced.

Nov 15, 2010 | Toyota RAV4 Cars & Trucks

1 Answer

Engine light comes on with code p1135 control fuel air metering. how do i fix this?


P1135: A/F Sensor Heater Circuit Malfunction (Bank 1 Sensor 1)

Your first O2 sensor is not getting heated either because the wiring to the sensor is bad or the heater inside the sensor is bad. If you have a four cylinder this would be the only O2 sensor you have before the catalyst. I would just replace the sensor, clear the code, and see if it comes back.

Nov 12, 2010 | 2001 Toyota Camry

1 Answer

Error code P 1135. what part needs to be replaced?


P1135. Air/Fuel Sensor Heater Circuit Response. (Bank 1 Sensor 1).

The P1135 code on your Toyota is Air fuel ratio sensor - heater circuit malfunction. Basically the problem there will be with the air/fuel ratio sensor (on other vehicles it is refered to as an O2 oxygen sensor), or the wiring/connectors leading to it. It could also be a problem with a fuse or relay on the heater circuit. Again, not a real difficult problem to solve.

Now, to specifically answer your question. I'm not familiar with the inspections in New Jersey, however just fixing the P1135 code will not cause the check engine light to stay off because there are other unrelated codes. If the code P1135 was causing the other problems then perhaps fixing that code would fix the others, but that's not the case here. The reality is you'll need to have all the problem areas looked at (IAT sensor, MAF sensor, Air/fuel ratio sensor) and repaired in order for your engine light to stay off. Normally if there are codes stored a vehicle cannot pass inspection. I would get a second opinion from another local mechanic as what you've been told may not be 100% correct.

Good luck.

Oct 02, 2010 | 2001 Toyota Sienna

1 Answer

I have 3 codes 1) P0500 2) P0125 3) P1135 1999 Lexus RX300


The PO125 is an indication of an engine running too cold-as if the thermostat were stuck open.For some reason it often sets with the PO1135 even when the engine runs at normal temp.A scan tool will indicate exactly how hot the engine is,don't trust the dash gauge. The PO1135 is a heater circuit fault in the bank1 sensor1 air fuel ratio sensor or oxygen sensor. Bank 1 is the REAR bank on this car...that O2 sensor is not much fun.PO500 is a vehicle speed sensor fault-does the speedo work correctly?it is located in the transmission near the back of the case. once again the scan tool will read vehicle speed and can aid in further diagnosis.

Mar 30, 2010 | 1999 Lexus ES 300

1 Answer

Check engine light came on.


P1135 means that your O2 sensor has gone bad. The O2 sensor on the Toyota's are called Air fuel sensor's. If you have a 4 cylinder engine, the O2 is on the exhaust down pipe before the catalytic converter, and if it's a V6 it the O2 sensor on the fire wall side along the down pipe from the exhaust manifold. (sensor 1, bank 1) Good luck and keep me posted, check the wire harness. The wire harness could have corroded or burnt from the exhaust, but most likely it's going to be a bad O2. Keep me posted ,be glad to help

Jun 08, 2009 | 2001 Toyota Camry

2 Answers

Check engine light on


This is a code that is indicating you have a problem with the "bank 1, O2 sensor 1" heater circuit. Bank one is the side of the engine that has cylinder #1, and sensor #1 is the O2 sensor on that side that is before the catalytic converter. This code sets when the computer senses that it either takes too much or too little current to drive the heater inside the O2 sensor. Typically, most shops would simply put a new O2 sensor in this location as it is ten years old and there is a good chance that the O2 sensor has burnt out However, there is a possibility that the driver circuitry has a problem as well.

I would replace the sensor, I believe it is the one on the passenger side between the engine and the cat. After that, you will have to drive it a bit for the code to cancel, or you could have it reset with a scan tool.

Mar 22, 2009 | 1999 Toyota 4Runner

Not finding what you are looking for?
2002 Toyota RAV4 Logo

456 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...