SOURCE: PO481 code Chevy IMPALA 2003
Looked it up in Chilton's, confirmed in http://www.obd-codes.com/trouble_codes/
P0481 Cooling Fan 2 Control Circuit Malfunction
Each fan will throw a different code. See 3 fans listed for your model. Here's a link for the wiring schematic: http://www.chiltonlibrary.com/content/images/WD/GM/014/WD_GM_014788.pdf
Best of luck.
Greg
SOURCE: Power door locks and driver side power window not
You can do it yourself.
Couple of times when you replace the remote battery, you might have them not working/ responding but just follow the procedure below.
Stand close to the car, hold down the open and close knobs for about 10 seconds. Press them at the same time for 3 seconds; then press the open button as the car opens.
The above procedure is applicable to a lot of car brands. It does not matter how many knobs you might have on the remote fob.
I have carried this procedure out on a lot of brands ranging from Honda, Toyota, Rover, Ford, etc. and it works perfectly well.
Good luck and Rate this.
Cheers
SOURCE: dome lights won't turn off
Been having a problem with the dome lights on a 99 chevy blazer. Still can't figure out what the problem is. There is a dome light overide button located under the dimmer wheel. When I push the overide button in the dome light goes off, but when I open any of the doors the dome light will not come on. When the overide button is out the dome light stays on all the time and will not turn off even though every door is closed. I checked all the pushbuttons and everything tests good. Has anyone had this problem and know how to fix it?
SOURCE: 2005 Chevy Colorado drivers side window, and power locks
Check for door ajar switches not making contact.
SOURCE: Power door locks and driver side power window not working
The solution to this issue was recently discovered during our most recent trip to the shop. We told them not to leave the window down when they changed the battery... BUT DID THEY LISTEN...NOOOO.
So quite by accident I was finally able to correct and then test fail the system and test and fix again...
Here you go.;
1. disconnect the battery and connect both the positive and negative cables together(after disconnected))
2. disconnect the window and lock controller in the driver's side door.
3. Leave cables connected for at least 5 minutes
4. Re-connect door window controller and locks wiring harness
5. Place the key in the ignition and turn to the run position
6. Connect Battery starting with the negative cable(ensuring not to connect then disconnect, (one swift motion)
7. open drivers side door and turn key to the off position(do not remove)
8. You should hear a series of dings
9 Once dings are heard remove the key from the ignition and you should hear the door lock solenoids activate..
10. Congrats.. Your done and the windows and locks work.
222 views
Usually answered in minutes!
×