The serpentine belt on my 2002 ford focus has come off and there is no diagram under the bonnet to show the correct routing to replace it. I have a new belt but cannot get it to fit.
Http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0996b43f802e8109 click on link to belt diagram.
SOURCE: belt routing diagram 98 zx2 2.0
1) Start with the alternator.
2) Forward to the smooth idler
3) Forward to power steering
4) Down to A/C compressor
5) Back to crank pulley
6) Forward around tensioner
7) Back glancing off of water pump
8) Back glancing off of ribbed idler
9) Up around alternator (where you started)
Good luck!
SOURCE: serpentine belt replacement
2.0L Engines
See Figures 11, 12 and 13
The
accessory drive belt for 2.0L engines has no provision for manual belt
adjustment, since these engines use an automatic belt tensioner. Drive
belt slack is taken up by the automatic tensioner.
Movement of
the automatic tensioner assembly during engine operation is not a sign
of a malfunctioning tensioner. This movement is the tensioner
self-adjusting and is required to maintain constant belt tension.
The belt tensioner has a belt length indicator. If the indicator marks are not between the MIN and MAX marks, the belt must be replaced.
Fig. 11: Drive belt routing-2.0L SOHC engine with A/C
Fig. 12: Drive belt routing-2.0L SOHC engine without A/C
Fig. 13: Drive belt routing-2.0L DOHC engine
SOURCE: please show diagram for replacing serpentine belt
How do you bypass the serpentine belt from the a/c compressor the reg belt is 85in
5,344 views
Usually answered in minutes!
×