SOURCE: jus changed oxegen sensor and
Get a code reader on this and relate the numbers to the fault possibilities. Go from there and good luck...accordianman
SOURCE: my check engine light does not flash when i turn key before start
bulb is probably blown... you have to remove the instrument cluster to change the bulb
SOURCE: The check engine light stays on or comes back on
Hi:
Your P0446 code is a Evap vent valve code:
Evap vent valve has only one purpose. It closes in order to seal the vent so the EVAP system can pressurize and ensure there are no leaks. Evap vent valve is usually supplied Batt. voltage with key on. The ECM's driver controls the ground, and when grounded, activates the valve (closing it). If the ECM detects a short to ground, and open,or a short to battery voltage on the control circuit, P0446 will set. Code also may refer to ECM detecting that EVAP system is unable to achieve or maintain vacuum during test.
Symptoms
There will be no obvious symptoms to driver, other than MIL illumination.
Causes
A code P0446 could mean one or more of the following has happened:
Possible Solutions
With a P0446 OBD-II trouble code, here are some things to try:
SOURCE: Got a P1404 Fault on
Regards,
Tony
227 views
Usually answered in minutes!
×