2000 buick century how to replace a coolant level sensor coolant light stays on 2000 buick century. Levels are good. How do I check or replace sensor?
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
4,820 views
Usually answered in minutes!
My 2003 Buick century coolant is boiling in the tank
gear/mileage light out
how do i replace the fuel level sensor on my 2000 chevy silverado
how do i replace the fuel level sensor on my 2000 chevy silverado
92 Buick Century dome light stays on when the car is on or off what to do to fix this problem
I have a 2000 Monte Carlo the coolant is full and I replace the coolant sensor low coolant level light will not go off
×