Replace crankshaft position sensor in 2003 dodge caravan 3.3 V6

Location of map sensor 98 grand caravan 3.0

Here's a link to your sensor,just enlarge picture to see. Repair Guides Component Locations 3 3l vg33er V6 Engine AutoZone com Here's what the sensor look's like. http://www.autozone.com/engine-management/crankshaft-position-sensor/duralast-crankshaft-position-sensor/nissan-datsun/frontier-pickup-2wd/2003/6-cylinders-3-3l-sfi-sc/229562_726118_0

Hi mate start at the easiest point which will be to check your EARTH to make sure everything is earthed.

The crankshaft position sensor mounts to the engine block behind the alternator near the oil filter.

1996 Dodge Truck Caravan 2WD 3.0L MFI 6cyl

The Crankshaft Position Sensor is located:Under hood, driver side, rear engine area, mounted top rear of engine .click here and enlarge picture,it's number 9,send picture to your library and you can enlarge even more.Here's the part.Here's how to remove.

Hi there:
The 3.3/3.8L crankshaft sensor is located on the rear of the transmission housing, above the differential housing (The bottom of the sensor is positioned next to the drive plate...






Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

2005 Dodge Caravan SE 2.4L Engine. Crank Shaft Sensor is located on the front of the engine (side toward the radiator) and right below the starter.
Raise the vehicle on stands or ramps. From under the vechcle, unclip the wire plug. Loosen and remove the 8mm bolt. Pull out old sensor.
This CAN be done WITHOUT removing the starter. Easiest way is to use a deep 8mm x 1/4” drive socket and good lighting. I had to use vise grips to grip and pul out the old sensor. It is okay to twist and pull.
NOTE: I have seen many posts placing this sensor in all kinds of places. For this vehicle, this is where it is located. If you have a different engine or year, it could be located someplace else.

Hello brscwb,

Below is an image depicting the location of the crank sensor.

I hope this helps.



Regards,

natven

Check the ignition wire that connects to the battery along with the big positive wire.

The 3.3/3.8L crankshaft sensor is located on the rear of the transmission housing, above the differential housing.