I just ran a OBDII scan on my 2003 Toyota Camry: LE; 4 Cyl 2.4L, automatic transmission in which it gave me a P0325 code. I know this has to do with the knock sensor. My question is, where is it located on this vehicle & what do I have to do to get to it in order to replace it?
SOURCE: Need to locate knock sensor on 1999 camry V6. Where is located.
i have toyota windom 4vz-fe i need locate knock sensor
SOURCE: Where is the thermostat located on the 1997 Toyota
Toyota Camry and Avalon 1997-2000
View of the thermostat and its components-5S-FE engine
Hoep helped with this. Good luck (remember rated this help).
SOURCE: Difficulty to replace EGR valve in 1999 totyota camry 4-cyl automatic
If you have small hands it can be easy. The space between firewall and EGR is tight but it wasn't too difficult to remove. The vacuum hose at the bottom was hard to pull off and I ended up cracking it and had to splice it. It was more difficult to re-install the EGR then remove it. I had a difficult time with keeping the gasket aligned while bolting it in to the lower tube. I took a few attempts. I suggest when replacing the EGR leave the mounting bolts loose so you can more easily align the metal tube. I would tighten the metal tube at the bottom of EGR first then tighten the upper two mounting bolts on top. It took me about 5 minutes to remove and 15 minutes to replace. I would be sure to clean the IAC too after cleaning the EGR. I sprayed throttle bottle cleaner down the bottom hole located on the throttle body and let soak about 15 minutes then start and run the engine a minute and repeat the process. This helped smooth the idle while stopped at a light. It also stopped the idle from shaking and almost stalling the car out at a traffic stop when the engine was warm.
SOURCE: 2003 Toyota Camry - Both Brake lights not working
Lok in the trunk on the left side, behind the carpet for a small plastic box with a bunch of wires going to it. Look to see if there is brake light powe coming in with the pedal depressed. If so, and no power is coming out, you need to order and replace the "taillamp failure sensor".
2,011 views
Usually answered in minutes!
×